JVC GR-DVP7U manual To end Self-Timer recording, select OFF in step

EN 53

Self-Timer

VIDEO/MEMORY Switch

Recording Start/

Stop Button

Once the camcorder is set, the camcorder operator can become part of the scene in a more natural way, adding the final touch to a memorable picture.

1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.

2Open the LCD monitor fully, or pull out the viewfinder fully.

●You can tilt the LCD monitor upward to 180° so that it faces forward and view yourself while self-recording with the viewfinder pushed back.

Power Switch

Lock Button

MENU Button

SET/SELECT Button +, – Button

3Set “SELF TIMER” to “ON ”. ( pg. 38)

4To engage the Self- Timer for video recording, press the Recording Start/Stop Button.

●After 15 seconds, the beep sounds and video recording starts.

5To stop Self-Timer recording, press the Recording Start/Stop Button again.

●The camcorder re- enters Record- Standby mode.

OR

SEL F – T I MER – OF F

ON

Self-Timer indication

5Press SNAPSHOT.

●After 15 seconds, the beep sounds and snapshot recording starts. After that, the camcorder re-enters Record-Standby mode.

6To end Self-Timer recording, select “OFF” in step 3.

NOTE:

If “BEEP” and “TALLY”are set to “OFF” ( pg. 47), the beep does not sound and the tally lamp does not light.

When the Recording Start/Stop Button or SNAPSHOT		Turns off
		(Self-Timer snapshot recording starts)
is pressed, the tally lamp changes as shown:
Begins blinking	Blinks quickly	Stops blinking and stays on
(Self-Timer starts)	(Self-Timer shooting	(Self-Timer video recording starts)
	starts soon)
	After approx. 15 sec.