8 EN
Automatic Demonstration
Automatic Demonstration takes place when “DEMO MODE” is set to “ON”
Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch is set to “A” or “M” and no cassette is in the camcorder.
Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minute after that, the demonstration will resume.
“DEMO MODE” remains “ON” even if the camcorder power is turned off.
To cancel Automatic Demonstration:
1)Set the Power Switch to “M” while pressing down the Lock Button located on the switch.
2)Open the LCD monitor fully, or pull out the viewfinder fully.
3)Press MENU. The Menu Screen appears.
4)Press + or – to select “s SYSTEM”, and press SET/ SELECT. The SYSTEM Menu appears.
5)Press + or – to select “DEMO MODE”, and press SET/ SELECT. The Sub Menu appears.
6)Press + or – to select “OFF”, and press SET/SELECT.
7)Press + or – to select “BRETURN”, and press SET/ SELECT twice. The normal screen appears.
NOTE:
Slide the lens cover down to see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.
MENU Button
SET/SELECT Button | +, – Button |
| |
Power Switch |
|
Lock Button
Sub Menu
DEMO MODE – OF F
ON