JVC GR-DVP7U 82 EN, Power, Video and D.S.C. Recording, Symptom Possible Causes Corrective Action

Page 82

82 EN

TROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Charger, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the beginning.

Power

SYMPTOM

POSSIBLE CAUSES

 

CORRECTIVE ACTION

1. No power is supplied.

1. •The power is not connected

1.

•Connect the AC Power

 

properly.

 

Adapter/Charger securely.

 

•The battery is dead.

 

( pg. 11)

 

•The LCD monitor is not open

 

•Replace the dead battery

 

fully or the viewfinder is not

 

with a fully charged one.

 

pulled out when recording.

 

( pg. 10, 11)

 

 

 

•Open the LCD monitor fully

 

 

 

or pull out the viewfinder.

 

 

 

 

Video and D.S.C. Recording

SYMPTOM

 

POSSIBLE CAUSES

CORRECTIVE ACTION

2. Recording cannot be

2. •The Power Switch is set to

2. •Set the Power Switch to “A”

performed.

 

“P” or “OFF”.

or “M”. ( pg. 14)

 

 

— For Video Recording —

— For Video Recording —

 

 

•The tape’s erase protection

•Set the tape’s erase

 

 

tab is set to “SAVE”.

protection tab to “REC”.

 

 

•The VIDEO/MEMORY

( pg. 16)

 

 

Switch is set to “MEMORY”.

•Set the VIDEO/MEMORY

 

 

•“TAPE END” appears.

Switch to “VIDEO”.

 

 

•The cassette holder cover is

•Replace with new cassette.

 

 

open.

( pg. 16)

 

 

— For D.S.C. Recording —

•Close the cassette holder

 

 

•The VIDEO/MEMORY

cover.

 

 

Switch is set to “VIDEO”.

— For D.S.C. Recording —

 

 

 

•Set the VIDEO/MEMORY

 

 

 

Switch to “MEMORY”.

 

 

 

3. When shooting a subject

3. •This is a result of exceedingly

3.

illuminated by bright light,

 

high contrast, and is not a

vertical lines appear.

 

malfunction.

 

 

 

 

 

4. When the screen is under

4.

•This is not a malfunction.

4.

direct sunlight during shooting,

 

 

the screen becomes red or

 

 

 

 

 

black for an instant.

 

 

 

 

 

 

 

5. During recording, the date/

5.

•“DATE/TIME” is set to “OFF”.

5. •Set “DATE/TIME” to “ON”.

time does not appear.

 

 

( pg. 38, 48)

 

 

 

 

Image 82
Contents For Customer Use Model No Serial NoDear Customer It is recommended that you…Before recording an important scene… Power Lines Power SourcesPower Cord Protection Grounding or PolarizationDamage Requiring Service Accessories To avoid personal injuryCleaning Replacement PartsRM-V717U Remote control unit USB Cable AV/Editing Cable Camcorder pg Attach the pad Adjust the length with the adjuster How To Attach The Grip BeltHow To Attach The Strap Remove the pad and separate the two strapsAutomatic Demonstration Getting Started 10 EN PowerCharging The Battery Pack About BatteriesUsing AC Power Using The Battery PackInformation Viewfinder Adjustment Grip Adjustment12 EN While using the viewfinder While using the LCD monitorTripod Mounting OFF Operation Mode14 EN VideoDate/Time Settings Built-in Clock’s Rechargeable Lithium BatteryLoading a Cassette Unloading a Cassette Approximate recording time Tape Recording mode16 EN To protect valuable recordings…Make sure the camcorder’s power is off Open the card cover To protect valuable files available only for SD Memory Card…18 EN Video Recording & PlaybackNow calculating Basic RecordingTape Remaining Time Blinking Blinking BlinkingJournalistic Shooting 20 ENZooming Interface ShootingRecording From The Middle Of a Tape When a blank portion is recorded on a tapeTime Code Proper recordingNormal Playback To control the speaker volume…22 EN Still PlaybackAvailable only with the remote control provided.  pg During Stop modeTo cancel Blank Search midway, press Blank Search24 EN Connections To a TV Or VCRHow to connect the S/AV/Editing cable 26 EN Recording & PlaybackBasic Shooting D.S.C. Snapshot To change the Image Size and/or Picture Quality,  pg28 EN Auto Playback Of ImagesPlayback Of Video Clips Viewing File Information 30 ENIndex Playback Of Files For Index Playback of video clip files, performIf you want to select another type of file, go to step Protect mode helps prevent the accidental erasure of filesProtecting Files On NextTo remove protection from the currently displayed file 32 ENTo Remove Protection To protect all files stored in the memory cardTo delete the currently displayed file Deleting FilesTo delete all files stored in the memory card Making a New Folder 34 ENFolder and File names SET/SELECT . To Reset The Number Of PrintsTo Print By Selecting Still Images And Number Of Prints Select36 EN Initializing a Memory CardAdvanced Features Menus without Sub Menus 38 ENMenus with Sub Menus Wipe Or Fader Effects VIDEO/MEMORY SwitchPress SET/SELECT again. The Menu Screen closes 40 EN Shutter 1/100 NightaliveShutter 1/60 SportsWhite Balance Adjustment 42 ENSound mode Recording modeCamera Menu 44 EN Snapshot mode for video recordingGain up Second Recording Self-TimerDigital Image Stabilization Manual Menu46 EN Maximum telephoto settingWide mode Wind cutSystem Menu Tally lamp settingAutomatic demonstration mode Beep, melody and shutter sound48 EN Display MenuQuality Fine Image sizeRecording media selection Standard50 EN Video MenuParameters are the same as in the description on Video/AV inputAV Input OFF Melody Tally OFF52 EN Motor Drive ModePress Snapshot Self-Timer To end Self-Timer recording, select OFF in stepAuto Focus Press SET/SELECT. Focus adjustment is complete54 EN Manual FocusPress Exposure Exposure ControlIris Lock To return to automatic exposure controlBacklight Compensation 56 ENTo return to automatic white balance… Downloading sound data from Web Site To cancel recording the sound effect midwayPress SET/SELECT Navigation Function To cancel Navigation search midway58 EN To make thumbnail images during tape recordingNavigation screen To add thumbnail images during tape playbackTo delete thumbnail images Appears Press + or to select EXECUTE, and pressMail Clip Recording 60 ENTo make video clips from real-time camera image To make video clips from recorded video footage 62 EN To use this camcorder as a recorderDubbing Dubbing To a Video Unit Equipped64 EN Equipped With a DV OUTSet Copy to Image  pg Press 4/9 to start Dubbing Still Images Recorded On a Tape To a Memory CardStill images can be dubbed from a tape to a memory card PlaybackBeam Effective Area indoor use Installing The Batteries66 EN Buttons And FunctionsPause in Connector With the camcorder’s PowerSwitch set to a or M Switch set to P FunctionsPlay 68 ENSlow-Motion Playback StopFilm ClassicPlayback Effect While holding A. DUB On the remote 70 ENAudio Dubbing To hear the sound during Audio DubbingAudio Dubbing Using Digital Sound Effects 72 EN Insert EditingSet Remote/VCR Code VCR Code List VCR Brand NameRandom Assemble Editing R.A.Edit You are now ready to try Random Assemble Editing74 EN Make ConnectionsSelect Scenes Recently registered point76 EN Automatic Editing To VCRDiagnosing VCR/Camcorder Timing Adjustment Of VCR/Camcorder TimingFor More Accurate Editing Value for Synchro Is highlighted78 EN Using USB cableUsing DV cable Connection To a Personal ComputerIf the PC is not WebCamThis camcorder can be used as a WebCam via USB connection Disconnect the USB cable from the camcorder and PC80 EN ReferencesNear a radio Power  pgItems Holder opens. Do not use force82 EN PowerSymptom Possible Causes Corrective Action Video and D.S.C. Recording200X. pg Switch is set to Video Switch to MemoryViewfinder indications blink VIDEO/MEMORY Set the VIDEO/MEMORY84 EN Advanced featuresPress Backlight Other problems 86 EN Cause damage.  pgRe-insert it, then check if Using Household AC Plug Adapter General Battery PrecautionsBattery Packs 88 ENMain Unit Memory CardsLCD Monitor Do NOT…About moisture condensation How To Handle a CD-ROM90 EN Serious malfunctioningAfter Use Cleaning The CamcorderHatch 92 EN USB VTR94 EN Controls ConnectorsIndicators Other Parts96 EN IndicationsCard Icon Image Size 1280 1280 x 960 1024 x 768 or 640 640 xShooting Icon Picture Quality F Fine and S Standard Order of qualityFlash indicator Operation ModeGain Up Mode 98 ENTape Speed Playback Headphone Level indicator g movesViewfinder Level indicator g moves Fast-Forward/Shuttle Search100 EN Unit in Safeguard Card ErrorSwitch Mode Remove102 EN Program AE With Special Effects Program AE Wide Mode Wide ModePlayback sound Recording TimeGR-DVP7