Cassette holder
PUSH Button | EJECT Switch |
Turn to take up slack.
Erase Protection | Gear |
EN11
Loading/Unloading A Cassette
1 OPEN LCD MONITOR
Open the LCD monitor to an angle of over 60 degrees.
2 OPEN CASSETTE HOLDER
Slide EJECT until the holder opens. Do not use force to open.
3 INSERT/REMOVE CASSETTE Make sure the label is facing outward.
4 CLOSE CASSETTE HOLDER
Press PUSH and make sure the holder is closed and locked.
5 CLOSE LCD MONITOR
First make sure the holder is closed. Then close the
LCD monitor.
NOTES:
●Closing the LCD monitor while the cassette holder is still open may cause damage to the LCD monitor.
●The cassette holder can’t be opened unless a power supply is attached.
●Make sure that the tape is not slack when loading the cassette. If there is any slack, turn the gear on the cassette in the direction of the arrow to take up the slack.
●Make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape.
●The cassette holder cannot be opened while the camcorder is in the record mode.