JVC GR-FXM35, GR-FXM55 LCD Monitor/Viewfinder Indications, Stop Recording, Press Display Button

Tape remaining time indicator

25MIN MIN

(Now calculating)

60MIN

59MIN

3MIN

2MIN

(Blinking)

1MIN

(Blinking)

0MIN

(Blinking)

Recording Start/Stop Button

DISPLAY Button

EN13

4	STOP RECORDING
	Press the Recording Start/Stop Button again to stop
	recording.
	•The camcorder re-enters the Record-Standby mode.
NOTES:
● When the Power Switch is set to “CAMERA” and the
LCD monitor is opened at an angle of 60 degrees or
more, the LCD monitor switches on and the viewfinder
switches off automatically to save power.
● The cassette holder cannot be opened unless a power
supply is attached.
● There may be a delay after you slide EJECT until the
holder opens. Do not use force.
● The tape remaining time is only displayed in the
viewfinder as shown.
● The remaining time indicated in the viewfinder is		RECORDING
correct tape length has been selected (☞ pg. 8).
approximate.
● The time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
according to the type of tape used.
● The tape remaining time indicator is correct only if the
● “TAPE END” appears when the tape reaches its end, and
the power goes off automatically if left in this condition
for 5 minutes. “TAPE END” also appears when a cassette
whose tape is already at its end is loaded.
● If the Record–Standby mode continues for 5 minutes
without performing Zoom or any other operations, the
camcorder’s power shuts off automatically. Set the
Power Switch to “POWER OFF”, and then back to
“CAMERA” to turn the camcorder on again.
● If the Recording Start/Stop button is pressed after the
Record-Standby mode has continued for over
5 minutes, recording may not start immediately.
● If you are recording on a cassette from the middle (such
as when a tape is removed and re-inserted during
recording), use the Retake function (☞ pg. 16) to find
the end of the last recording so you don’t erase any of it.
● The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on with the cover closed.
● While shooting, sound is not heard from the speaker.
● To turn the tally lamp off during recording, refer to pgs.
24 and 26.
LCD Monitor/Viewfinder Indications
Press DISPLAY to make the following indications appear/
disappear from the camcorder’s display: cassette warning,
tape remaining time, battery pack remaining power
indicator and tape length indicator (☞ pg. 52).
1	PRESS DISPLAY BUTTON
	To turn off the indications, press DISPLAY for more
	than 1 second.
	Press again for more than 1 second to make the
	indications reappear.
NOTE:
Even if the indications are off, the tape remaining time
appears blinking when the tape is near its end, and the
battery pack remaining power indicator appears blinking
when the power is almost gone.