JVC GR-FXM15 No power is supplied, Recording does not start, Playback picture, Interrupted

Page 51

TROUBLESHOOTINGEN51

If, after following the steps in the chart below, the problem still exists, please consult your JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.) and clock battery; and then re-connect it and proceed as usual from the beginning.

SYMPTOM

 

POSSIBLE CAUSE(S)

POWER

 

 

No power is supplied.

 

The battery pack has not been attached correctly

 

 

(pg. 6).

 

 

The battery pack is not charged (pg. 6).

 

 

The power supply has not been correctly connected

 

 

(pg. 7).

 

 

 

The power suddenly goes off and

 

The battery pack has completely discharged.

does not come back on by itself.

 

Remove the cassette and disconnect the power source, then

 

 

after a few minutes, try turning the power back on. If it still

 

 

does not come on, consult your nearest JVC dealer.

 

 

 

RECORDING

 

 

Recording cannot be performed.

 

Make sure the Erase Protection tab is in the position that

 

 

allows recording. If not, slide the tab. Some cassettes have

 

 

removable tabs. If the tab has been removed, cover the

 

 

hole with adhesive tape.

 

 

 

Recording does not start.

 

The camcorder Power Switch has not been set to

 

 

“CAMERA” (“AUTO“ or “PRO.“.) (pg. 14).

 

 

 

PLAYBACK

 

 

The tape is running, but there is no

 

The TV has not been set to its VIDEO mode or channel.

playback picture.

 

If A/V connection is used, the TV’s VIDEO/TV Switch has

 

 

not been set to VIDEO.

 

 

 

Playback picture is blurred or

 

The video heads are dirty or worn out. Consult your nearest

interrupted.

 

JVC dealer for head cleaning or replacement.

 

 

 

The counter indication is blurred

 

This is normal.

during Still playback.

 

 

 

 

 

TAPE TRANSPORT

 

 

The tape stops during fast-forward or

 

The Counter Memory Function has been activated

rewind.

 

(pg. 38).

Rewinding or fast-forwarding cannot

The tape is already fully wound on one reel or the other.

be performed.

 

Image 51
Contents GR-FXM15 91/157/EEC and 93/86/EEC Dear CustomerIt is recommended that you Connection to the mains supply in the United KingdomAbove ALL EN3EN Major Features Quick Operation Guide EN5 Slide Battery Release and pull out the battery packPower Charging the Battery PackUsing the Battery Pack Using AC Power Using a CAR BatteryChoose which one means charged and which means discharged Getting Started Clock Lithium Battery Insertion/RemovalDate/Time Settings Cont Recording Mode SettingTape Length Setting EN Getting StartedClose Cassette Holder Loading/Unloading a CassetteOpen LCD Monitor Open Cassette HolderViewfinder Adjustment Grip AdjustmentAttach Strap Adjust LengthShoulder Strap Attachment Tripod MountingStart Shooting Power Switch PositionBasic Recording Load a CassetteLCD Monitor/Viewfinder Indications Stop RecordingPress Display Button Recording Basic Recording Shooting While Watching The LCD MonitorBefore the following steps, perform pg Journalistic Shooting Interface ShootingBrightness Control EN Recording Basic Features Push the Power Zoom Lever towards TZoom Feature Quick Review To check the end of the last recordingTo re-record certain segments Press P.STABILIZER. appears Basic FeaturesFeature Picture Stabilizer Feature 5Sec. Rec 5-sec. RecordingStart or END Recording Recording Advanced Features EN21Tomodecancel FADE- or WIPE-STANDBY Fade/WipePress P.AE to cycle through the modes as shown on the left Advanced FeaturesSelect Mode Programme AE With Special EffectsColours of a picture are reversed Display ModeNega Posi mode High shutter speed clearly captures fast-moving actionRecording Advanced Features Date/Time InsertPress the Select Dial to display the Menu Screen Instant Titles Access Title MenuUsing Menu For Detailed Adjustment Make SettingEND Setting Menu Screen Available Using The Select Dial Menu Screen Available Using The Menu ButtonMenu Screen Explanations Recording pg Tally lamp comes on to signal the start of recordingDemo Mode is set to on and the Menu Screen is closed Allows you to set the current date and time pgAccess Exposure Menu Exposure ControlTo darken the image Patterns that are regularly repeated FocusingRecording Auto FocusManual Focus Access Focus MenuAccess Manual Focus END Adjustment of FocusTo Return To Automatic White Balance White Balance AdjustmentAccess White Balance Adjustment SET Function ParametersTo Change The Tint For Recording Enter SettingManual White Balance Operation Press the Select Dial again to close the Menu ScreenSET Interval Time Self-TimerAccess INT. Time Menu Start Delayed RecordingTime-Lapse AnimationStop Playback Playback Basic PlaybackRewind or Fast-Forward the tape Play BackTracking Playback FeaturesSpeaker Volume Control Adjust VolumeFeature Counter Memory Function Playback FeaturesFeature Still Playback Feature Shuttle SearchUsing The Cassette Adapter EN39 Insert BatteryCassette Adapter Connection For Tape Dubbing When connecting the cables, open this coverBasic Connections And Tape Dubbing Basic ConnectionsTape Dubbing RM-V700U optional Functions Buttons Installing The BatteryPull OUT Battery Holder Remote control uses one lithium battery CR2025Time-Lapse Feature Self-Timer, Animation and Time-LapseSelf-Timer AnimationYou are now ready to try Random Assemble Editing Using the Remote Control UnitSET REMOTE/VCR Code Operate VCRPrepare Camcorder Make ConnectionsJVC VCR Equipped with Remote Pause Terminal VCR Other than Type orSelect Scenes Start Source PlaybackRegister END of Scene END Automatic Editing Automatic Editing to VCRPrepare Source Tape Begin Automatic EditingInsert Editing EN Using the Remote Control UnitAudio Dubbing Begin Audio DubbingEND Audio Dubbing After Use Cleaning The CamcorderPlayback picture is blurred or No power is suppliedRecording does not start Playback pictureTape will not eject An error number i.e. E03 appearsReview or Retake mode During recording, the indications do not appearIndex Indications 54EN Battery Pack Mount Dioptre Adjustment Control Lens Cover Open/Close RingBattery Release Switch Tally Lamp Power LampDarken The LCD Monitor High Speed Shutter Mode ......................... pgRemote Control Pg , 7During use For safety, do notAvoid using the unit To avoid hazardTo prevent damage to the LCD monitor, do not Cleaning the video heads To prolong service lifeDo not leave the unit To protect the unit, do notConnectors Provided Accessories Optional AccessoriesGeneral GR-FXM15