Focusing, EN45, Auto Focus, Manual Focus

Focus detection zone

NOTES:

●If the lens is smeared or blurred, accurate focusing is not possible. Keep the lens clean, wiping with a piece of soft cloth if it gets dirty. When condensation occurs, wipe with a soft cloth or wait for it to dry naturally.

●When shooting a subject close to the lens, zoom out first ( pg. 20). If zoomed in in the auto focus mode, the camcorder could automatically zoom out depending on the distance between the camcorder and the

subject. This does not occur with “TELE MACRO” ( pg. 42).

REFRESH Button

DSC Lamp

MENU Wheel

Power Switch

EN45

Focusing

AUTO FOCUS

The camcorder’s Full Range AF system offers continuous shooting ability from close-up to infinity. However, correct focus may not be obtainable in the situations listed below (in these cases use manual focusing):

•When two subjects overlap in the same scene.

•When illumination is low.*

•When the subject has no contrast (difference in brightness and darkness), such as a flat, one-color wall, or a clear, blue sky.*

•When a dark object is barely visible in the viewfinder.*

•When the scene contains minute patterns or identical patterns that are regularly repeated.

•When the scene is affected by sunbeams or light reflecting off the surface of a body of water.

•When shooting a scene with a high-contrast background.

*The low-contrast warning “ ” appears.

MANUAL FOCUS

Make the necessary viewfinder adjustments to use the viewfinder ( pg. 10).

1 Set the Power Switch to “ ”. Press REFRESH for approx. 1 second to select “VIDEO” (the DSC Lamp goes out) or “DSC” (the DSC Lamp comes on).

2 Press the MENU Wheel in. The Menu Screen appears.

3 Rotate the MENU Wheel to select “FOCUS” and press it. The FOCUS Menu appears.

4 Rotate the MENU Wheel to select “MANU”, then press it. The Menu Screen disappears and “” and “” appear. The focus is locked at this point.

5 To focus on a farther subject, rotate the MENU Wheel upward. “” appears and blinks.

To focus on a nearer subject, rotate the MENU Wheel downward. “” appears and blinks.

6 Press the MENU Wheel in. The setting is complete. The Menu Screen reappears with the highlight bar on “RETURN”.

7 Press the MENU Wheel in. The Menu Screen

disappears and “ ” reappears to indicate the focus is locked.

NOTES:

●To return to Auto Focus, select “AUTO” in step 4.

●To re-adjust Manual Focus, repeat the procedure from step 2.

●Be sure to focus the lens in the maximum telephoto position when you use the Manual Focus mode. If you focus in on a certain subject in the wide-angle position, sharply focused images cannot be obtained when zoomed in because the depth-of-field is reduced at longer focal lengths.

●When the focus level cannot be adjusted any farther or closer, “” or “” will blink.