JVC GR-SXM530 specifications 52EN

52EN	USING THE REMOTE CONTROL UNIT (cont.)
	REFRESH Button	Insert Editing (VIDEO)

COUNTER R/M Button

DSC Lamp

Power Switch

Display

w

			Insert editing
			indicator
M– 0 : 1 2 : 3 4			Tape Counter
	e4		Audio dubbing
M– 0 : 0 5 : 2 0			indicator
		During Audio
		Dubbing

Remote sensor

Microphone

You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the remote control unit to perform this procedure.

1 Set the Power Switch to “ ”. If the DSC Lamp is lit, press REFRESH for approx. 1 second to select “VIDEO”.

2 Play back the tape, locate the Edit-Out point and press PAUSE (6).

3 Press and hold COUNTER R/M on the camcorder for more than 1 second to reset the tape counter, then press it again for less than 1 second so that “M” appears.

4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the Edit-In point where the new scene should start.

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE on the Remote Control. The Insert Editing indicator appears and the Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

6 To begin Insert Editing, press START/STOP. When the counter reaches “0:00:00”, editing stops automati- cally and the camcorder enters the Insert-Pause mode.

7 To end Insert Editing, press STOP.

NOTES:

●During Insert Editing, the original audio will be heard from the speaker.

●After step 5, Retake (
pg. 21) can be performed.

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only the video signal is recorded in the Insert Editing mode.

START/STOP

PLAYFF

REWPAUSE

STOPA.DUB INSERT