48EN
TROUBLESHOOTING
SYMPTOM | POSSIBLE CAUSE(S) |
POWER |
|
No power is supplied. | ● The battery pack has not been attached correctly |
(☞ pg. 4).
● The battery pack is not charged (☞ pg. 4).
● The power supply has not been correctly connected (☞ pg. 5).
The power suddenly goes off and doesn’t come back on by itself.
●The battery pack has completely discharged.
●Remove the cassette and disconnect the power source, then after a few minutes, try turning the power back on. If it still doesn’t come on, consult your nearest JVC dealer.
RECORDING
Recording cannot be performed. | ● Make sure the Erase Protection tab is in the position that |
| allows recording. If not, slide the tab. Some cassettes have |
| removable tabs. If the tab has been removed, cover the |
| hole with adhesive tape. |
|
|
Recording does not start. | ● The camcorder Power Switch has not been set to |
| “CAMERA” (☞ pg. 12). |
PLAYBACK
The tape is running, but there’s no playback picture.
●The TV has not been set to its VIDEO mode.
●If A/V connection is used, the TV’s VIDEO/TV Switch has not been set to VIDEO.
●The RF unit has not been set to the correct channel.
Playback picture is blurred or | ● The video heads are dirty or worn out. Consult your |
interrupted. | nearest JVC dealer for head cleaning or replacement. |
|
|
The counter indication is blurred | ● This is normal. |
during Still playback. |
|
|
|
TAPE TRANSPORT |
|
The tape stops during | ● The Counter Memory Function has been activated |
or rewind. | (☞ pg. 36). |
|
|
Rewinding or | ● The tape is already fully wound on one reel or the other. |
cannot be performed. |
|