JVC LYT0002-0P1A Manual White Balance Adjustment M.W.B, Select White Balance, Adjust Focus

SET

SEL.

LCD monitor or viewfinder

PROGRAM AE	M.W.B.
select dial	MWB

No indicationMWB (Auto)

White balance mode indicator

NOTES:

●To switch to automatic white balance adjustment, press SET until the indication disappears, or turn the PROGRAM AE select dial to “AUTO LOCK”.

●Re-adjust the White Balance when the lighting has changed, when the camcorder has been turned off and on again, or when the PROGRAM AE select dial’s position has been changed.

●When adjusted by putting coloured paper in front of the subject in step 2 (“ADJUST FOCUS”), this unit makes its colour temperature standard for automatic white balance. So you can enjoy shooting with different colours. For example, when adjusting with red, blue or yellow colours, the image becomes the colour which aproximates to green, orange or purple respectively.

●Manual White Balance Adjustment is not

possible when the PROGRAM AE dial is set to SEPIA (☞ pg. 21).

EN 29

Manual White Balance Adjustment (M.W.B.)

This camcorder’s Automatic Colour Temperature system senses the colour temperature of the ambient lighting for automatic white balance adjustment. However, precise colour adjustment is not possible under the following conditions:

•When an object is in various shades of the same colour. •When a predominantly red or brown object is being

shot outdoors.

In these cases, use the camcorder’s built-in preset filters for white balance adjustment.

SELECT MODE

1 Turn the PROGRAM AE select dial to any position except AUTO LOCK.

SELECT FUNCTION

2 Press SEL. repeatedly until “M.W.B.” appears.

SELECT WHITE BALANCE

3 Press SET (Manual White Balance) until the required indication appears in the LCD monitor or the viewfinder.

“MWB” .... With a memorized personal White

Balance setting (see below) “ ” ......... Outdoors on sunny day

“” ........ Outdoors on cloudy day

“” ......... Light source is halogen or tungsten lamp

MWB

MWB sets the colour temperature for the subject’s light source so you can shoot with natural colours that are unaffected by surroundings, even when there are multiple subjects with different colour temperatures.

SELECT MODE

1 Turn the PROGRAM AE select dial to any position except AUTO LOCK.

ADJUST FOCUS

2 Point the camcorder at a white, flat object such as a sheet of white paper, and adjust focus manually (☞ pg. 23).

ADJUST WHITE BALANCE

3 Press SET until “MWB” appears, then press and hold SET for more than 3 seconds.

•“MWB” blinks in the LCD monitor or the view- finder during adjustment, then stops blinking but stays lit when adjustment is complete.