Prepare Camcorder, Prepare VCR, Make Corrections

JVC LYT0002-0P1A specifications Prepare Camcorder, Prepare VCR, Access R.A. Edit Counter Display

40EN

EDITING (cont.)




REW/FF		STOP
	PLAY/PAUSE

IN/OUT

CANCEL

R.A. EDIT

PREPARE CAMCORDER

2 Insert a recorded tape and set the Power switch to “PLAY”.

PREPARE VCR

3 Turn the power on, insert a recordable tape and engage the AUX mode (refer to VCR’s instructions).

SELECT SCENES

ACCESS R.A. EDIT COUNTER DISPLAY

1 Press PLAY/PAUSE, then press R.A. EDIT and the counter display appears in the viewfinder and the screen of the connected TV.

REGISTER BEGINNING OF SCENE

To AUDIO and VIDEO out connectors

Audio and Video cable (optional)

To AUDIO

and VIDEO IN connectors

If your TV/VCR has the SCART connector, use the provided cable adapter.

Open the cover

To J terminal (JLIP)

Editing cable (provided)

A B

To Remote

PAUSE

To Pause-In

2 Press REW or FF to locate the beginning of a scene you want, then press IN/OUT to register that point. The data appears under IN on the display.

REGISTER END OF SCENE

3 Press REW or FF to locate the end of the scene and press IN/OUT to register it. The data appears under OUT on the display. The total time of the registered scene(s) is displayed at the bottom of the screen.

REGISTER ADDITIONAL SCENES

4 Repeat steps 2 and 3 for each additional scene (as many as 8).

MAKE CORRECTIONS

5 Press CANCEL during steps 2 and 3 to erase the most recently registered point.

NOTES:

VCR (Recording deck)
		MBR
		(provided)
			IN/OUT
			CANCEL
		VCR REC STBY
				ON/OFF
IN	OUT		IN	OUT
ç 1 0:00:25	-- : -- : --	ç 1	0:00:25	0:01:05
2		2	0:03:18	0:03:31
3		3	0:02:33	0:02:53
4		4	0:04:11	-- : -- : --
5		5
6		6
7		7
8		8
COUNTER	0:00:25	COUNTER		0:04:11
TOTAL	0:00:00	TOTAL		0:01:13

●The MBR can be used to operate other camcorder functions as well. Point the MBR at the camcorder’s remote sensor and press any of the following buttons (function appears in parentheses):

—ON/OFF (camcorder R.A. EDIT)

—IN/OUT (camcorder IN/OUT)

—CANCEL (camcorder CANCEL)

●There must be at least one second between an in-point and its corresponding out-point.

●To ensure correct operation, there should be at least 15 seconds between an out-point and the next in-point.

●Blank portions of tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing doesn’t take place.

●Pressing R.A.EDIT clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.