JVC LYT0261-001B manual Basic Shooting, Mode Selection, Still Image Storage

22EN

DIGITALSTILLCAMERA(D.S.C.)SHOOTING

SNAPSHOT Button LENS COVER Open/Close Ring

System

Select

Switch

MENU Button

Power lamp

Basic Shooting

When shooting a still image, it is not recorded onto the tape, but it is stored in the camcorder's built-in memory in the selected Picture Mode. A stored still image data can be transferred to a PC, saved, and processed using a Paint Software program (☞ pg. 53).

A still image processed on the PC can be also inserted onto a tape (☞ pg. 63).

MODE SELECTION

1 SELECTMODE OPERATION SYSTEM AND

Turn the LENS COVER Open/Close Ring to open the lens cover, then set the System Select Switch to “D.S.C.”. Set the Power Switch to “PRO.”.

• The power lamp lights and an image appears.

2 SELECT PICTURE MODE

Select Dial

Display

4NEXT

M. W. B. AUTO

D . ZOOM ON TELE MACRO OFF DATETIME TAPE LENGTH T30

PICTURE FINE

SNAPSHOT FULL

4RETURN

SNAPSHOT

FULL

PIN UP

MULTI 4

MULTI 9

M. DRIVE

Power Switch

Menu Screen

SNAPSHOT Menu

Do steps 2 and 3 of “OPERATION” on pg. 24. Set “PICTURE” to “FINE” or “STANDARD” in the Menu Screen as required.

•There are two modes: FINE allows you to shoot up to approx. 30 still images with higher resolution, and STANDARD allows you to shoot up to approx. 60 still images with lower resolution.

3 SELECT SNAPSHOT MODE

Rotate the Select Dial to move the highlight bar to “SNAPSHOT”, and press it. The SNAPSHOT Menu appears.

Rotate the Select Dial to move the highlight bar to the appropriate mode among the 5 Snapshot modes (☞ pg. 23), and press it. Selection is complete.

4 CLOSE MENU SCREEN

The Menu Screen reappears with the highlight bar on “RETURN”. Press the Select Dial again to close the

EXIT

Menu Screen.

4NEXT		AUTO	Menu Screen
M. W. B.
D . ZOOM		ON
TELE MACRO		OFF
DATE TIME
TAPE LENGTH T30
PICTURE		FINE
SNAPSHOT		PIN-UP
4RETURN
Normal Screen
		During Snapshot mode
		P		No display
		(Pin-Up)		(Full)
	P
		MD (M.DRIVE)		M4 (MULTI-4)
		M9 (MULTI-9)

STILL IMAGE STORAGE

1 TAKE SNAPSHOT

Press SNAPSHOT.

•Regardless of the Power Switch position (“AUTO” or “PRO.”), Snapshot recording takes place using the selected Snapshot mode.

•A still image is stored in the built-in memory and displayed for approx. 2 seconds. While the still image remains displayed, that image is in the process of being stored in memory, and it is therefore impossible to take another shot during that time. When the still image disappears and the scene you are currently aimed at appears on the screen, you may take another shot.

•The remaining number of shots available is displayed.