JVC LYT0261-001B manual To avoid hazard, Do not burn, To prevent damage and prolong service life

Page 74

74EN

CAUTIONS

DANGER:

Video Light

The video light becomes extremely hot. Do not touch it either while in operation or soon after turning it off, otherwise serious injury may result.

Do not place the camcorder into the carrying case immediately after using the video light, since it remains extremely hot for some time.

When operating, keep a distance of about 30 cm (1 ft.) between the video light and people or object.

Do not use near flammable or explosive materials.

It is recommended that you consult your nearest JVC dealer for replacing the video light.

When using the AC Power Adapter/Charger in areas other than the USA

The provided AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to 240 V.

USING HOUSEHOLD AC PLUG ADAPTER

In case of connecting the unit’s power cord to an AC wall outlet other than American National Standard C73 series type use an AC plug adapter, called a “Siemens Plug”, as shown.

For this AC plug adapter, consult your nearest JVC dealer.

Plug adapter

Battery Packs

 

The battery packs are nickel-cadmium

 

or nickel metal-hydride batteries.

 

Before using the supplied battery pack

 

or an optional battery pack, be sure to

 

read the following cautions:

 

1. To avoid hazard . . .

 

... do not burn.

Terminals

... do not short-circuit the terminals.

 

... do not modify or disassemble.

 

... use only specified chargers.

 

2.To prevent damage and prolong service life . . .

... do not subject to unnecessary shock.

... avoid repeated charging without fully discharg- ing.

... charge in an environment where temperatures are within the tolerances shown in the chart below. This is a chemical reaction type battery—cooler temperatures impede chemical reaction, while warmer temperatures can prevent complete charging.

... store in a cool, dry place. Extended exposure to high temperatures will increase natural discharge and shorten service life.

... avoid prolonged uncharged storage.

... remove from charger or powered unit when not in use, as some machines use current even when switched off.

General Battery Precautions

When the C-P6U or C-P7U (cassette adapter) is not functioning even when correctly operated, the battery is exhausted. Replace it with a fresh one.

Use only the following battery:

C-P6U or C-P7U..................... AA (R6) size

Please make note of the following rules for battery use. When misused, battery can leak or explode.

1.Refer to the C-P6U/C-P7U instructions when replacing the battery.

2.Do not expose the battery to excessive heat as it can leak or explode.

3.Do not dispose of battery in a fire.

4.Remove battery from the unit if it is to be stored for an extended period to avoid battery leakage which can cause malfunctions.

NOTES:

It is normal for the battery pack to be warm after charging, or after use.

Temperature Range Specifications

Charging

10°C to 35°C (50°F to 95°F)

Operation

0°C to 40°C (32°F to 104°F)

Storage

–10°C to 30°C (14°F to 86°F)

Recharging time is based on room temperature of 20°C.

The lower the temperature, the longer recharging takes.

Image 74
Contents For Customer Use Model No Serial NoIt is recommended that you For clock operation and remote control unitDear Customer Power Lines Power SourcesPower Cord Protection Grounding or PolarizationDamage Requiring Service AccessoriesCleaning Replacement PartsZoom Zoom out Cassettes marked can be used with this camcorderSlide Battery Release and pull out the battery pack Using the battery packTo remove the battery pack Image you shoot is recorded onto a video tapeOpen/Close Ring Set to Auto or PRO Quick Operation Guide D.S.C. EN7Snapshot Button Contents Unit RM-V705U For Windows PC Cassette AdapterVHS Playpak C-P7U BN-V20U Shoulder Strap DC Cord Software programsUsing the Battery Pack PowerCharging the Battery Pack Charge Marker Using AC PowerUsing a CAR Battery Choose which one means charged and which means dischargedClock Lithium Battery Insertion/Removal Getting StartedDate/Time Settings EN Getting Started Recording Mode SettingTape Length Setting ContOpen Cassette Holder Loading/Unloading a CassetteOpen LCD Monitor Close Cassette HolderGrip Adjustment Viewfinder AdjustmentTripod Mounting Adjust LengthShoulder Strap Attachment Attach StrapLoad a Cassette Power Switch PositionBasic Recording Start ShootingStop Recording Tape remaining time indicatorLCD Monitor/Viewfinder Indications Press Display ButtonBefore the following steps, perform pg Power Switch Recording Start/Stop ButtonPower lamp Tally lamp Lights while recording is in progress Brightness Control Journalistic ShootingInterface Shooting Still Image Storage Mode SelectionBasic Shooting Remaining number of shots 30 29 1 Snapshot mode with no frameMotor Drive mode Picture mode display Feature Picture Mode SettingSnapshot Button System Select Switch Menu Button Normal ScreenEN25 Snapshot Recording Basic FeaturesSnapshot Mode Selection Display ex. Pin-Up If you press during Record-Standby modeSnapshot Recording Zoom Basic FeaturesPush the Power Zoom Lever towards T To check the end of the last recording Feature Quick ReviewFeature Picture Stabilizer To re-record certain segmentsLight OFF/AUTO/ON Switch Feature Video LightTo brighten the scene when natural lighting is too dim Advanced Features EN31 Fade/WipeProgram AE With Special Effects Advanced FeaturesSelect Mode Press P.AE to cycle through the modes as shown on the leftTwilight SepiaSports ND EffectMonitor, as well as to record them manually or Recording Advanced FeaturesDate/Time Insert AutomaticallyPower Switch Menu Screen Title Menu Access Title MenuSystem Select Switch Select Dial Display Instant TitlesEND Setting Using Menu For Detailed AdjustmentMake Setting System Select Switch Select Dial Menu ButtonMenu Screen Explanations Menu Screen Available Using The Select DialMenu Screen Available Using The Menu Button Displayed only with the System Select Switch set to D.S.C Maximum telephoto setting. When set to ON, you can shoot aDisplayed with the System Select Switch set to either Video Tally lamp comes on to signal the start of recordingTo darken the image Access Exposure MenuExposure Control Auto Focus FocusingRecording Patterns that are regularly repeatedEND Adjustment of Focus Access Focus MenuAccess Manual Focus Manual FocusSET Function Parameters White Balance AdjustmentAccess White Balance Adjustment To Return To Automatic White BalancePress the Select Dial again to close the Menu Screen Enter SettingManual White Balance Operation To Change The Tint For RecordingStart Delayed Recording Self-TimerAccess INT. Time Menu If you set the System Select Switch to VideoAnimation Time-LapsePlay Back Video Playback Basic PlaybackRewind or Fast-Forward the tape Stop PlaybackAdjust Volume Video Playback Features EN47Speaker Volume Control TrackingFeature Shuttle Search EN Video Playback FeaturesFeature Still Playback Feature Counter Memory FunctionRecording safety hole Video Playback Using The Cassette Adapter EN49Insert Battery Cassette Adapter VHS PlaypakBasic Connections When connecting the cables, open this coverBasic Connections And Tape Dubbing Connection For Tape DubbingTape Dubbing To move Back C. Playback Basic PlaybackBecomes blue Connect to Personal Computer Connection EN53Connection to a Windows PC END TransferringSlide-show will start pg C. Playback Advanced FeaturesProtect pg , Delete pg , 59 and do each procedure from step If you select any other functionsMenu Screen Explanations Mode EffectNever remove the power supply unit at this stage View Index Images Access Index MenuIndex Playback ScreenSET Protect Access Protect MenuProtect Way To complete Protect, go to stepTo quit the Delete Mode Access Delete MenuSelect Delete Mode DeleteAccess Delete Execute Menu X T DeleteRemote control uses one lithium battery CR2025 Installing The BatteryPull OUT Battery Holder FunctionsAnimation Feature Self-Timer, Animation and Time-LapseSelf-Timer Time-LapseEN Using the Remote Control Unit Insert Editing VideoTo insert still images in sequential order onto the tape Built-in Memory Onto a TapeSelect Still Image Press REW 2/PAGE- or FF 3/PAGE+ to move the page forwardEND Audio Dubbing Audio DubbingBegin Audio Dubbing Remote sensor Microphone Set to VideoCleaning The Camcorder After UseDuring recording, the indications do No power is suppliedSome functions are not available Not appearWhen the System Select Switch is set to Video When the System Select Switch is set to D.S.C Clock Battery Warning Zoom Level Indicator Approximate Zoom RatioInterval Timer/Recording Time Indicator Tape Remaining TimeIndex Controls, Connectors And Indicators 70ENMENU/DISPLAY Button Counter Reset/Memory Button Video Light SwitchSystem Select Switch Recording Mode Button SP/EPIndex Terms Digital Still CameraShooting Pg , 57Do not burn To prevent damage and prolong service lifeTo avoid hazard Plug adapterDuring use For safety, do notAvoid using the unit Store cassettesAbout moisture condensation To prolong service lifeTo prevent damage to the LCD monitor, do not Serious malfunctioningGeneral ConnectorsProvided Accessories Optional Accessories Carga DE LA Bateria AlimentaciónAtencion USO DE LA BateriaUtilización de la batería Deslice Battery Release y extraiga la bateríaGuia Para Operacion Rapida Vodeo EN79 Para extraer la bateríaBotón REW 2/PAGE FF 3/PAGE + Por más detalles, p aPor más detalles, p Botón SnapshotHOW to Locate Your JVC Service Center For Servicing Only in U.S.A. EN81EN Warranty Only in U.S.A Memo EN83 GR-AXM910