JVC LYT0944-001A 95F C to 25C 68F to 77F is the ideal temperature range for, Battery pack

DETAILS	EN 47
I T E M S	N O T E S
➪ Power	❍ Perform charging where the temperature is between 10°C and 35°C (50°F
	and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for
( pg. 8)
	charging. If the environment is too cold, charging may be incomplete.
	❍ Charging times are for a fully discharged battery pack.
	❍ Charging time varies according to the ambient temperature and the status of
	the battery pack.
	❍ To avoid interference with reception, do not use the AC Adapter near a radio.
	❍ Since the AC Adapter processes electricity internally, it becomes warm
	during use. Be sure to use it only in well-ventilated areas.
	❍ The following operation stops charging:
	• Set the Power Switch to “PLAY”, “ ” or “ ”.
	• Disconnect the AC adapter from the camcorder.
	• Unplug the AC adapter from the AC outlet.
	• Detach the battery from the camcorder.
➪ RECORDING	❍ When you use the LCD monitor outdoors in direct sunlight, the LCD monitor
( pg. 15, 16)	may be difficult to see. If this happens, use the viewfinder instead.
	❍ The cassette holder cannot be opened unless a power supply is attached.
	❍ There may be a delay after you open the cassette holder cover until the
	cassette holder opens. Do not use force.
	❍ Once the cassette holder is closed, it recedes automatically. Wait until it
	recedes completely before closing the cassette holder cover.
	❍ When the Recording Start/Stop button is pressed, it may take a few seconds
	before actual recording starts. “ ” starts rotating when the camcorder
	actually starts recording.
	❍ The time required to calculate and display the remaining tape length, and the
	accuracy of the calculation, may vary according to the type of tape used.
	❍ “TAPE END” appears when the tape reaches its end, and the power goes off
	automatically if left in this condition for 5 minutes. “TAPE END” also appears
	when a cassette at its end is loaded.