Tuner source

What might seem to be a malfunction in your unit may

just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.

General

?The power does not turn ON. (/ The fuse has blown.

=+ After checking for short circuits rn the wares, replace the fuse with one-with the same ratrng.

(/ No ACC posrtron on vehicle rgnrtron

*Connect the same wrre to the rgnitron as the battery wrre

?Nothing happens when the buttons are pressed.

I/ The computer chrp rn the unit is not functronrng normally u* Press the reset buttor? on the unrt (page 5)

?There’s a source you can’t switch.

/There’s no CD Inserted

m* Set the medra you want to Men to If there’s no media rn thus unit. you can’t swhich to each source.

?The memory is erased when the ignition is turned OFF.

4 The battery wrre has not been connected to the proper terminal us* Connect the wrre correctly, referring to the sectron on

/The rgnrtron and battery wrre are rncorrectly connected

1; Connect the wire correctly, referring to the sectron on <Connectlnq Wires to Termrnals>.

?Even if Loudness is turned ON, high-pitched tone isn’t compensated for.

(/ Tuner source IS selected

~1 High-prtched tone Isn’t compensated for when I” Tuner source

?No sound can be heard, or the volume is low.

4 The fader or balance settings are set all the way to one srde c- Center the fader and balance settrngs

/The lnputioutput wires or wrnng harness are connected rncorrectly c-i Reconnect the Input/output wires or the wrnng harness correctly

See the sectron on <Connectrng Wires !o Termrnals>

?The sound quality is poor or distorted.

/ One of the speaker wires IS being prnched by a screw rn the car. = Check the speaker wirrng,

(/ The speakers are not wrred correctly

c* Reconnect the speaker wires so that each output terminal IS connected to a different speaker.

?The Touch Sensor Tone doesn’t sound. (/ The preout lack IS berng used.

03 The Touch Sensor Tone can’t be output from the preout lack

?Radio reception is poor.

/The car antenna is not extended GI- Pull the antenna out all the way

4The antenna control wire IS not connected.

~1 Connect the wrre correctly, referring to the sectron on <Connectrng Wares to Termrnals>.

-2l-