DVC20_Eng.book 11 ページ ２００５年１０月３１日 月曜日 午前１０時３６分
Before using
Inserting/removing a cassette
1Slide the [OPEN/EJECT] lever and open the cassette cover.
OPEN/
EJECT
≥When the cover is fully opened, the cassette holder will come out.
2After the cassette holder is opened, insert/remove the cassette.
≥When inserting a cassette, orient it as shown in the figure, and then securely insert it as far as it goes.
≥When removing, pull it straight out.
3Push the [PUSH] mark 1 in order to close the cassette holder.
1
PUSH
4Only after the cassette holder is completely housed, close the cassette cover.
≥After using, make sure to rewind the cassette completely, remove it, and put it in a case. Store the case in an upright
position.
≥When condensation is formed on the lens or the main unit of the
ªWhen the cassette holder does not come out
≥Close the cassette cover completely, and then open it again completely.
≥Check if the battery has run down.
ªWhen the cassette holder cannot be housed
≥Set the [OFF/ON] switch to [OFF], then to [ON] again.
≥Check if the battery has run down.
ªInserting/removing the cassette
≥When the cassette holder is in action, do not touch anything except the [PUSH] mark.
≥When inserting a previously recorded cassette, use the blank search function to find the position where you want to continue recording. If you
≥Close the cassette cover tightly.
≥When closing the cassette cover, do not get anything, such as a cable, caught in the cover.
ªAccidental erasure prevention
If the accidental erasure prevention slider 1 of a cassette is opened (slide in the direction of the [SAVE] arrow), the cassette cannot be recorded. When recording, close the accidental erasure prevention slider of the cassette (slide in the direction of the [REC] arrow).
1
R E C
SAVE
11