Cord routing (example)
ORoute the camera cord so that it does not allow rainwater etc. to penetrate.
OAllow enough slack in the cord so that it is not pulled when the door is opened and closed.
Hatchback or Van type
Cord clamp
Harness cover
Tie band
Tie to the harness cover.
Route the cord above the back door (outside).
Fasten with cord clamps at key points, then bring the cord in where the clearance from the edge of the door is wider.
Do not route the cord under the back door (inside).
The cord will be damaged if pinched by the edge of the back door.
Car navigation etc. | Rear view camera |
Rear view camera control unit
Cord rail
(peel off backing paper) Cut to the appropriate size.
Rear view camera cord
Rubber water seal (Attached to rear view camera.)
Place against the rubber gasket and bring the cord into the interior.
Cord clamp