Panasonic CY-RC50KU Observe the following warnings when installing, Grounded vehicle

Page 7

Warning

Observe the following warnings when installing.

R Use on a DC 12 V

grounded vehicle.

This system can only be used on a DC 12 V

grounded vehicle. It cannot be used in DC 24 V

and other battery system (large trucks, diesel

vehicles for use in cold regions, etc.). Use on

such vehicles would cause fire and breakdown.

R Disconnect the battery

terminal during

performing any wiring or installation work. Wiring or installation work with the battery

terminal connected could cause electric shock and injury from shorting.

R This system should be installed in a way so that operation of vehicle protective devices such as an air bag is not hindered.

Should this system be installed in a vehicle with a protective device such as an air bag or an anti-theft system, check with the car manufacturer about operational cautions prior to attempting installation and perform the installation in a safe and proper manner. Improper removal of the battery may result in a malfunction of a device or possibly death.

R Never use the security parts of the vehicle for mounting or grounding the system. Use of the bolts or nuts of security parts (steering, brake systems, fuel tank etc.) can cause brake failure, fire, or other accidents.

R Check positions of pipes, tanks, electric wirings in the vehicle when mounting. Never interfere with or touch pipes, tanks, or electric wirings when opening holes in the vehicle body for installation. Apply rust prevention and waterproofing treatments to the processed area, as rust or water leakage may result in a fire, an electric shock, or other accident.

R Route cords so that they do not get in the way of occupants driving or getting into or out of the vehicle.

Route cords so that they do not tangle with the steering wheel, shift lever, brake pedals, feet etc., and bundle and fasten them appropriately. Poorly arranged cords can cause accident and injury.

R Wire and mount the system as instructed. Fire or accident could result if wiring and mounting do not properly follow the operating instructions.

R Do not attempt to disassemble, repair or modify the system.

Never attempt to disassemble, repair or modify the system, or to remove cord insulation to take power supply from other devices. Fire, electric shock or accident could result.

R After mounting and wiring the system, check that all vehicle systems function normally. If any vehicle equipment (brakes, lights, horn, hazard and indicator lights etc.) does not work normally, fire, electric shock or accident could result.

R Keep screws and other small components away from small children.

There is a risk that they could swallow small components. Seek immediate medical attention if that happens.

Image 7
Contents English CY-RC50KUSevere injury or death Safety informationObserve the following warnings when using this unit Operating instructionsOnly use the accessories provided and the parts specified Observe the following cautions when using this unitDo not damage cords Problem Possible cause Possible solution TroubleshootingIf you suspect something wrong Npcparts@panasonic.com Customer services directoryAccessory Purchases Service in Puerto RicoDivision of Panasonic Rico, Inc. PSC SpecificationsPanasonic Consumer Electronics CompanyGrounded vehicle Observe the following warnings when installingDo not display a direct view of the sun for long periods Check the mounting of the system components regularlyDisclaimers Product servicing MaintenanceReplacing the Fuse Panasonic Auto Products Limited Warranty Limited warrantyCheck the contents Hatchback or Van type Cord routing exampleView with trunk lid closed Sedan typeRear view camera Rubber gasket Rear view camera Mounting procedureQFor secure mounting Rear view camera control unit Velcro tape Rear view camera control unitMounting on carpet etc Mounting on hard surfaces floor etcWiring procedure Connection to a Car Monitor example Connection to a Car Navigation System exampleReverse lead RCA cord How to disconnect locked cordsHow to attach a clip connector Power cord Rear view camera CordDo not re-attach the adhesive Mount the camera body onto the camera bracketSide view Camera field of viewMemorandum