Panasonic CY-RC50KU Mounting procedure, Rear view camera, QFor secure mounting

Page 14

Mounting procedure

Rear view camera

Before mounting Wipe away all oil and dirt etc. from the mounting surface.

Make connections and placement tentatively at ﬁrst, to check positions. Repeated afﬁxing weakens the adhesive.

OThe screw holes to use, and the possible angle adjustment, vary according to the mounting position. Adjust the angle and check that the required ﬁeld of view is visible. (It is not possible to re-afﬁx components.)

OMount the camera so that it does not contact the vehicle body or rear wipers.

QFor secure mounting

ODo not work outdoors in rainy weather.

OWhen the air temperature is low, use the vehicle’s interior heater or defogger, or a dryer, to warm the bonding area.

OUse a dryer etc. to thoroughly remove all moisture. Dirt and moisture on the bonding surface reduce bond strength and could cause the camera to fall off.

OAfter mounting the camera, do not expose it to rain or other water, pull it or subject it to strong forces for 24 hours.

Note:

OThe camera cannot be afﬁxed to painted or glass surfaces which have been treated with ﬂuoroplastics (treatments which shed water droplets, mud etc.), or to re-painted surfaces.

Image 14

Contents CY-RC50KU EnglishOperating instructions Safety informationObserve the following warnings when using this unit Severe injury or deathDo not damage cords Observe the following cautions when using this unitOnly use the accessories provided and the parts speciﬁed If you suspect something wrong TroubleshootingProblem Possible cause Possible solution Service in Puerto Rico Customer services directoryAccessory Purchases Npcparts@panasonic.comElectronics Company SpeciﬁcationsPanasonic Consumer Division of Panasonic Rico, Inc. PSCObserve the following warnings when installing Grounded vehicleDisclaimers Check the mounting of the system components regularlyDo not display a direct view of the sun for long periods Replacing the Fuse MaintenanceProduct servicing Limited warranty Panasonic Auto Products Limited WarrantyCheck the contents Cord routing example Hatchback or Van typeRear view camera Rubber gasket Sedan typeView with trunk lid closed QFor secure mounting Mounting procedureRear view camera Mounting on hard surfaces ﬂoor etc Rear view camera control unitMounting on carpet etc Rear view camera control unit Velcro tapeWiring procedure Connection to a Car Navigation System example Connection to a Car Monitor examplePower cord Rear view camera Cord How to disconnect locked cordsHow to attach a clip connector Reverse lead RCA cordCamera ﬁeld of view Mount the camera body onto the camera bracketSide view Do not re-attach the adhesiveMemorandum