[Failed to connect wireless access point]/[Connection failed]/ [No destination found]
•Check following regarding the wireless access point (broadband router).
>The wireless access point (broadband router) information set on this unit is wrong. Check the authentication type, encryption type, and encryption key.
>Power of the wireless access point (broadband router) is not turned on.
>Setting of the wireless access point (broadband router) is not supported by this unit.
•Check the network setting of the destination.
Troubleshooting
First, try out the following procedures.
•Check “Troubleshooting” in the “Owner’s Manual for advanced features (PDF format)”.
If the problem is not resolved, it may be improved by selecting [Reset] on the [Setup] menu when taking pictures.
Battery and power source
The camera cannot be operated even when it is turned on. The camera turns off immediately after it is turned on.
•The battery is exhausted. Charge the battery.
•If you leave the camera on, the battery will be exhausted.
>Turn the camera off frequently by using the [Economy] etc.
Card/battery door does not close.
•Insert the battery securely all the way in.
Recording
The picture cannot be recorded.
•Is the mode set to [Rec] Mode?
•Is there any memory remaining on the
>Delete the pictures which are not necessary to increase the available memory.
•You may not be able to record for a short while after turning the power [ON] when using a large capacity card.
(ENG) VQT3S29 29