
Table 1-13. Server Module Messages (continued)
Message | Causes | Corrective Actions |
|
|
|
DIMMs must be populated in | The specified DIMM is inaccessible to | Populate two, four, or eight DIMMs |
sequential order beginning | the system due to its location. | sequentially beginning with slot 1. |
with slot 1. The following | DIMMs must be populated in |
|
DIMM is electrically | sequential order, beginning with |
|
isolated: DIMM x. | slot 1. |
|
|
|
|
DIMM pairs must be matched | Mismatched or unmatched DIMMs | Ensure that all pairs of memory modules |
in size, speed, and | installed; faulty or improperly seated | are of the same type and size, and that |
technology. The following | memory modules. | they are properly installed. See "General |
DIMM pair is mismatched: |
| Memory Module Installation |
DIMM x and DIMM y. |
| Guidelines" on page 78. See |
|
| "Troubleshooting Server Module |
|
| Memory" on page 112. |
|
|
|
Diskette drive n seek | Incorrect configuration settings in | Run the System Setup program to |
failure | System Setup program. | correct the settings. See "Using the |
|
| System Setup Program" on page 43. |
| Faulty or improperly connected | Replace the diskette. Ensure that the |
| diskette or optical drive to the custom | diskette drive and optical drive cables are |
| cable. | properly connected. See |
|
| "Troubleshooting USB Devices" on |
|
| page 105. |
|
| |
Diskette read failure | Faulty or improperly inserted diskette. Replace the diskette. | |
|
|
|
Diskette subsystem reset | Faulty diskette drive or optical drive | Ensure that the diskette drive and |
failed | controller. | optical drive cables are properly |
|
| connected to the custom cable. See |
|
| "Troubleshooting USB Devices" on |
|
| page 105. If the problem persists, see |
|
| "Getting Help" on page 127. |
|
|
|
Drive not ready | Diskette missing or improperly | Reinsert or replace the diskette. |
| inserted in diskette drive. |
|
Error: Incorrect memory configuration. DIMMs must be installed in pairs of matched memory size, speed, and technology.
Mismatched or unmatched DIMMs installed; faulty or improperly seated memory modules.
Ensure that all pairs of memory modules are of the same type and size, and that they are properly installed. See "General Memory Module Installation Guidelines" on page 78. If the problem persists, see "Troubleshooting Server Module Memory" on page 112.
36