Dell 1955 Ensure that all memory modules are, Modules, or faulty server module, Board, Hard drive

Table 1-13. Server Module Messages (continued)

Message	Causes	Corrective Actions
Memory address line	Faulty or improperly installed memory	Ensure that all memory modules are
failure at address, read	modules, or faulty server module	properly installed. See "Troubleshooting
value expecting value	board.	Server Module Memory" on page 112. If
Memory double word logic		the problem persists, see "Getting Help"
		on page 127.
failure at address, read
value expecting value
Memory odd/even logic
failure at start address
to end address
Memory write/read failure
at address, read value
expecting value
Memory mirroring enabled	Memory mirroring enabled	Information only.
Memory tests terminated by	The spacebar was pressed during	Information only.
keystroke	POST to terminate the memory test.
No boot device available	Faulty or missing diskette drive,	Check the Integrated Devices
	optical drive, or hard drive.	configuration settings in the System
		Setup program and ensure that the
		controller for the boot device is enabled.
		See "Using the System Setup Program"
		on page 43. Ensure that the controller
		for the boot device is enabled.
		If the problem persists, replace the drive.
		See "Hard Drives" on page 89.
No boot sector on	An operating system is not on the	Check the hard-drive configuration
hard-disk drive	hard drive.	settings in the System Setup program.
		See "Using the System Setup Program"
		on page 43.
No timer tick interrupt	Faulty server module board.	See "Getting Help" on page 127.
Not a boot diskette	Not a bootable diskette.	Use a bootable diskette.
PCI BIOS failed to install	Faulty or improperly installed.	Reseat the daughter card. See "I/O
		Module Daughter Card" on page 82. If
		the problem persists, see "Getting Help"
		on page 127.

38

About Your System