Dell 1955 owner manual Server Modules, Removing a Server Module, Lower handle

4Reconnect any cables that must be attached to the module.

See the documentation that accompanied the I/O module for information about its cable connections.

Server Modules

Your system can include up to 10 hot-pluggable server modules. Each server module can contain up to two processors, two hard drives, six memory modules, and one daughter card.

Removing a Server Module

1Ensure that the server module's power is off.

When a server module is powered off, its front-panel power indicator is amber. See Figure 1-3.

2Press in the release latch on the inside of the upper handle. See Figure 3-11.

3Pull out both the upper and the lower handles to eject the server module from the chassis.

4Slide the server module out of the chassis.

NOTICE: If you are permanently removing the server module, install a server module blank. Operating the system for extended periods of time without a server module blank installed can cause the system to overheat.

Figure 3-11. Removing and Installing a Server Module

1

2

		5
			4	3
1	chassis	2	upper handle		3	server module
4	lower handle	5	release latch inside of upper
			handle

Installing System Options

73