![](/images/new-backgrounds/1188000/188000197x1.webp)
Figure 3-26. Removing and Installing the System Board
2
1
1 screws (8) | 2 | system board |
Installing the System Board
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.
1Carefully lower the new system board into the chassis.
2Reinstall the five Phillips screws and three hexagonal screws.
Use the center screw near the back edge of the board to reinstall the chipset cooling shroud.
3Replace the processor(s). See "Installing a Processor" on page 86.
4Replace the memory modules and memory module blanks. See "Installing Memory Modules" on page 80.
5If applicable, replace the daughter card See "Installing a Daughter Card" on page 82.
6Reconnect the control panel cable to the system board. See Figure
7Replace the hard drive(s).
If you are installing two drives, be sure and reinstall them in their original locations.
8Close the server module. See "Closing the Server Module" on page 76.
9Install the server module in the system. See "Installing a Server Module" on page 74.
Installing System Options
99