Panasonic NV-GS230EB Inserting/removing a cassette, When the cassette holder does not Come out

Page 11

Before using

parentheses indicate the recordable times when the LCD monitor is used.

$We recommend the Battery Pack CGA-DU12, CGA-DU14 and CGA-DU21 for long time recording (2 hours or more for continuous recording, 1 hour or more for actual recording).

$The actual time may become shorter than this. The recordable time shown in the table are approximations. The recordable time will become shorter in the following cases: $When you use both the viewfinder and the

LCD monitor simultaneously while rotating the LCD monitor frontward to record yourself, using the 0 lux night view function, etc.

$When you use this camera with the LCD monitor lit up by pressing the [POWER LCD] button.

$The batteries heat up after use or charging. The main unit of the movie camera being used will also heat up. This is normal.

$Along with the reduction of the battery capacity, the display will change: !"!"#"!" $"!"%"!"&. If the battery discharges, then % (&) will flash.

Inserting/removing a cassette

1Slide the [OPEN/EJECT] lever and open the cassette cover.

OPEN/

EJECT

$When the cover is fully opened, the cassette holder will come out.

2After the cassette holder is opened, insert/ remove the cassette.

$When inserting a cassette, orient it as shown in the figure, and then securely insert it as far as it goes.

$When removing, pull it straight out.

3Push the [PUSH] mark ! in order to close the cassette holder.

1

PUSH

4Only after the cassette holder is completely housed, close the cassette cover.

$After using, make sure to rewind the cassette

completely, remove it, and put it in a case. Store the case in an upright position. (-56-)

$When condensation is formed on the lens or the main unit of the movie camera, even if no condensation alarm is indicated, condensation may have formed on the heads or the cassette tape. Do not open the cassette cover. (-54-)

%When the cassette holder does not

come out

$Close the cassette cover completely, and then open it again completely.

$Check if the battery has run down.

%When the cassette holder cannot be

housed

$Set the [OFF/ON] switch to [OFF], then to [ON] again.

$Check if the battery has run down.

%Inserting/removing the cassette

$When the cassette holder is in action, do not touch anything except the [PUSH] mark.

$When inserting a previously recorded cassette, use the blank search function to find the position where you want to continue recording. If you overwrite-record on a previously recorded cassette, be sure to find the position where you continue recording.

$Close the cassette cover tightly.

$When closing the cassette cover, do not get anything, such as a cable, caught in the cover.

%Accidental erasure prevention

If the accidental erasure prevention slider !$of a cassette is opened (slide in the direction of the [SAVE] arrow), the cassette cannot be recorded. When recording, close the accidental erasure prevention slider of the cassette (slide in the direction of the [REC] arrow).

!

R E C

SAVE

11

VQT0T87

Page 10 Page 12
Image 11
Page 10 Page 12
Contents NV-GS180EB Before use How to replace the FuseRemove the connector cover Carefully observe copyright laws Information for Your SafetyContents Sales and Support Information AccessoriesAC adaptor, DC input lead, AC mains lead Battery pack OptionalCamera Parts identification and handlingCassette holder Volume lever /VOLAccessory shoe Shoulder strap fixture NV-GS180Fitting the lens cap Using the LCD monitorAdjust the belt length and the pad position Adjust the angle of the LCD monitor as you preferPower supply Using the viewfinderCharging time and recordable time Connecting to the AC outletFitting the battery Removing the batteryInserting/removing the cassette When the cassette holder does not Come outWhen the cassette holder cannot be Housed Inserting/removing a cassetteSD Memory Card Card access lampInserting/removing a card Concerning the cardTurning the camera on Selecting a modeHow to use the joystick Set Language select the desired language Switching the languageCard recording mode AUTO/MANUAL/FOCUS switch is set to Auto To exit the menu screen Using the menu screenAbout the menu setting Operating with remote controlAbout date/time Setting date and timeAdjusting LCD monitor/viewfinder Adjusting the brightness and colour LevelChanging the picture quality on LCD monitor Using the remote controlRemote control Order to increase the brightness Entire LCD monitorInstall a button-type battery Selecting the remote control mode Remote control usable rangeBasic camera holding About auto modeRecording mode Check before recordingRemove the lens cap On-screen display in the tape recording modeRecording on a tape Concerning the remaining tape time Indication on the screenStopping blank search midway Through Check the recordingBlank search function Recording still pictures onto a card PhotoshotSelect the size of still pictures to be Recorded on a card On-screen display in the card recording modeConcerning the focusing area Progressive PhotoshotTo use the zoom microphone function Zoom in/out functionRecording yourself Digital zoom functionTo return to normal recording To cancel the quick start when Power is set to OFFQuick start Backlight compensation functionNight view functions Soft skin modeTo cancel the colour night view Function To cancel the soft skin modeFade in/fade out function To cancel the tele-macro functionTo cancel fading Tele-macro functionRecording images for wide-screen TVs Self-timer recordingWind noise reduction function Continuous Photoshot To cancel the image stabilizer function$Set to Tape Recording Mode Set Advance SIS on Image stabilizer functionTo cancel the scene mode function Recording in various situations Scene modeRecording in natural colours White balance To restore to automatic adjustment Manual focus adjustmentManual shutter speed/aperture adjustment Iris/gain value range Manual iris/gain adjustmentShutter speed range Slow-motion playback/ frame-by-frame playback To adjust volumeSettings on the audio Playing back tapeFrame-by-frame playback Press the Play . button on the remote controlVariable-speed search function To return to normal playbackPlaying back card Press the EXT Display button on the remote control$Set to Picture Playback Mode Operate with joystick Playback on TVTo delete all files Deleting files recorded on a cardTo display multiple playback files About the compatibility of still picturesProtecting files on a card Writing the printing data on a card Dpof settingFormatting a card $The image and sound are reproduced Edit modeRecording from a tape onto a card Copying onto a DVD recorder or a VCR DubbingUsing the DV Cable for Recording Digital Dubbing To dub audio while listening to a Pre-recorded sound $Set to Tape Playback ModeAudio dubbing To play back the sound recorded with Audio dubbingSet Print YES to start printing When you stop printing halfwayUSB cable Select the paper sizeBasic DATE/TIME -45-AV Jack Menu listMenu Basic DATE/TIME -45-PROTECT SetupButton Switches the audio PCM audio recording systemsMenus related to taking pictures Press the recording start/stopOther menus Menus related to playbackPlayback indications IndicationsBasic indications Recording indicationsTextual indications Confirmatory indicationsCheck the connected printer Functions cannot be used simultaneouslyThere is no ink. Check the connected printer There is no paper. Check the connected printerMovie camera power does not stay on long enough Before requesting repair Problems and solutionsPower/Body Movie camera power cannot be turned on Movie camera power is turned off automaticallyScreen has changed suddenly Remote control does not functionCassette cannot be removed No operation other than cassette removal can be performedSounds cannot be played back Original sound was erased when audio dubbing was performedDifferent sounds are reproduced at the same time Audio dubbing cannot be performedOthers Push the Reset Switch is displayedCamera mode During playback, Unplayable Card is displayedAbout the movie camera About condensationAbout dirty heads While carrying the movie camera, do not drop or bump it About the batteryBe sure to detach the battery after use Prepare spare batteries when going out for recordingFolder structure of the card About the AC adaptorAbout the cassette About the cardAutomatic white balance Explanation of termsAuto focus White balanceThis Site is English only SpecificationsSpecifications Http//panasonic.co.jp/pavc/global/csPicture Numerics IndexFor business users in the European Union VQT0T87 F1105Nm1126 3000 F
Top Page Image Contents