Editing Features
Copying from Digital
Equipment (dubbing)
High quality
Source (Playing)
Palmcorder
DV Input/Output
(i.LINK) Connector
Recording
Palmcorder
DV Interface Cable (i.LINK) (optional)
Before you begin
•Connect both Palmcorders to their power sources.
•Connect the two Palmcorders using the DV Interface cable (i.LINK)
•Turn both Palmcorders ON.
1 Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
2 Insert a blank tape with the record tab closed into the target (recording) Palmcorder and set POWER to VCR.
3 Press 
(PLAY) on the source Palmcorder. When the tape reaches the point from which you want to start dubbing, press 
(PAUSE).
4 Hold down 
(REC) and press
(PLAY) on the target (recording) Palmcorder.
Press 
(PAUSE) to pause the tape at the starting point of the dub.
4REC | 3, 4PLAY |
6STOP 3, 4, 5PAUSE
5 Simultaneously, press 
(PAUSE) on both units to begin dubbing.
6 Press 
(STOP) on the recording unit, and then press 
(STOP) on the playing unit to end dubbing.
Note
•When two Palmcorders are used for dubbing, it is recommended that the Remote Control (Optional) VCR1 or VCR2 setting be used to avoid improper- operation.
Optional
3, 4, 5
PAUSE
6STOP
4REC
3, 4
PLAY
CAUTION:
Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.
48