ªInserting a Button-type Battery
1 |
| Before using the Remote Controller, insert the supplied |
| 1 While pressing the Stopper 1, pull out the Battery Holder. | |
|
| |
|
| 2 Insert the |
|
| upward. |
|
| 3 Insert the Battery Holder into the Remote Controller. |
|
| ≥When the |
|
| battery. (A battery is normally expected to last about 1 year. However, it |
| 1 | depends on operation frequency.) |
| ≥Make sure to match the poles correctly when inserting the battery. | |
|
| |
2 |
| ......................................................................................................................... |
| CAUTION | |
|
| |
|
| Danger of explosion if battery is incorrectly replaced. Replace only with |
|
| the same or equivalent type recommended by the equipment |
|
| manufacturer. Discard used batteries according to manufacturer’s |
|
| instructions. |
|
| ......................................................................................................................... |
3 |
| WARNING |
| Risk of fire, explosion and burns. Do not recharge, disassemble, heat |
above 100xC or incinerate. Keep the
.........................................................................................................................
1
15˚ 15˚
15˚ 15˚
~~~~~~~~~~~~~~~~~~~~~~~~~
ªUsing the Remote Controller
1Direct the Remote Controller to the Remote Control Sensor of the Movie Camera and press an appropriate button.
≥Distance from the Movie Camera: Within approximately 5 metres
≥Angle: Within approximately 15o in the vertical and horizontal directions from the central axis
≥The above operative ranges are for indoor use. Outdoors or under strong light, the Movie Camera may not operate properly even within the above ranges.
≥Within a
(the LCD Monitor side) of the Movie Camera.
Selecting Remote Controller Modes
DATE/ PHOTO
OSD TIME SHOT
COUNTER RESET TITLE
MULTI/
START/
STOP
ZOOM
T
sVOLr
When 2 Movie Cameras are used simultaneously, they can be operated individually by selecting different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie Camera and that of the Remote Controller do not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS]
Setup on the Remote Controller:
2
V/REW | PLAY | FF/W | W | [VCR1]: Press the [D] Button and [∫] Button simultaneously. 1 |
6 | 1 | 5 | ||
STILL ADV | PAUSE STILL ADV |
| [VCR2]: Press the [E] Button and [∫] Button simultaneously. 2 | |
E | ; | D |
| ≥When the battery in the Remote Controller is replaced, the mode is |
INDEX | STOP | INDEX |
| |
K | ∫ | L | 1 | automatically reset to [VCR1] Mode. |
SELECT | VAR. |
| P.B. |
|
|
|
| ||
| SEARCH |
| ZOOM |
|
STORE
| MENU |
OFF/ON | SET |
| |
P.B.DIGITAL | ITEM |
|
9