Parts and their functions
73
8 2
(Eye cup)
:
9
56 1 4
1POWER switch
Move this switch while pressing the lock release button.
=
<
;
4Cassette holder
5CAM REMOTE jack (2.5 mm mini jack) |
The remote control unit is connected to this |
ON
OFF
POWER
Lock release button
jack to enable zooming and record start/stop |
to be initiated by remote control. |
6PHONES jack (3.5 mm stereo mini jack) The headphones are connected to this jack to monitor the sound.
2START/STOP button
When this button is pressed in the camera mode, shooting can be started or stopped. Operation is switched between the camera mode and VCR mode using the CAMERA/VCR button >.
3EJECT switch
To open the cassette holder, slide this switch in the direction of the arrow while pressing the lock release button.
Do not operate the switch while recording is in progress. The cassette holder will open but recording will continue, so external light and/or dust will adversely affect the tape.
O Do not insert or eject the cassette tape holding onto the cassette holder alone.
Insert or eject the tape with the camera recorder placed on a flat and stable surface or, alternatively, support the camera recorder with both hands so that it will be kept in a stable condition even if the cassette holder is opened.
O Close the cassette holder after ensuring that the cassette mechanism has completed the eject operation.
|
| T |
| C | |
JE |
| |
E |
|
|
Lock release button
7Remote control sensor (rear)
8Tally lamp (rear)
This lights or blinks depending on the status of the camera recorder.
Lights: While shooting is in progress.
Blinks:
O When a remote control operation has been received (about 8 blinks per second)
O When shooting is commenced (about 8 blinks per second)
O When the tape has come to the end (about 4 blinks per second)
O When a problem has arisen in the tape transport system (about 4 blinks per seconds)
O When there is little tape or battery charge remaining (once a second)
The settings for causing the tally lamp to flash are performed using the REC LAMP item on the setting menu OTHER FUNCTIONS screen. (See page 46)
9Viewfinder
:Diopter adjustment dial
This is adjusted in such a way that the viewfinder screen comes into sharp focus.
;Power socket
<DC INPUT connector (7.9V)
=Battery eject button
10