Beforeusing
Charging time and recordable time
,i
The times shown in the tables below are for when
the temperature is 25 °C (77 °F) and the humidity is 60%. If the temperature is higher or lower than 25 °C (77 °F), the charging time will become longer.
Supplied | (A_ | l | h40min | |
battery! | ._ | 1 h 45 | min | |
|
| (1 h 25 | min) | |
(7.2 V/ | _ |
| 45 min | |
640 mAh) |
|
| (40 min) | |
| (A_ | 2 h 25 | min | |
(7.2 V/ | (_ | 3 | h 10 | min |
1150 mAh) |
| (2 h 40 | min) | |
| (_ | 1 h 25 | min | |
|
| (1 h 10 | min) | |
| (A_ | 3 h 56 | min | |
(7.2 V/ | (_ | 5 | h 30 | min |
2040 mAh) |
| (4 | h 30 | rain) |
| _ | 2 | h 30 | min |
|
| (2 | h 05 | min) |
(_ Charging time
(s_ Maximum continuously recordable time _ Actual recordable time
(The actual recordable time refers to the recordable time on tape when repeatedly starting/ stopping recording, turning the unit on/off, moving
the zoom lever etc.)
"1 h 40 rain" indicates 1 hour 40 minutes. oThe battery
oThe charging time and recordable time shown in
the table are approximations. The times indicate the recordable time when the viewfinder is used.
The times in parentheses indicate the recordable time when the LCD monitor is used.
oWe recommend the Battery Pack
•The actual time may become shorter than this. The recordable time shown in the table are
approximations. The recordable time will become shorter in the following cases: =When you use both the viewfinder and the
LCD monitor simultaneously while rotating the LCD monitor frontward to record yourself, etc.
•The batteries heat up after use or charging. The main unit of the Camcorder being used will also heat up. This is normal.
•Along with the reduction of the battery capacity,
the display | will change: | _ | _ _ | |
_ | ,_ | _ _. |
| If the battery |
discharges, | then | _ | ( _ | ) will flash. |
Turning the Camcorder on
When the Camcorder is turned on with the lens
cap fitted, the automatic white balance adjustment
•How to turn on the power
1While pressing the button 0, set the [OFF/ON] switch to [ON].
oThe Status indicator lights red and the power turns on.
=In Tape Recording Mode or Card Recording Mode, if the [OFF/ON] switch is set to [ON] while the LCD monitor is closed and the
viewfinder is retracted, the power turns off.
How to turn off the power
1 While pressing the button 0, set the [OFF/ON] switch to [OFF].
4,-
@
•Set the [OFF/ON] switch to [OFF] when not using the Camcorder.
•The Status indicator goes off when the power turns off.
LSQT1121