Bosch Appliances BasicDome Series instruction manual Fastaddress, Fast Address

Indoor Pendant & In-ceiling Models Instruction Manual FastAddress EN 13

4FASTADDRESS

The following is an example of FastAddressing a BasicDome (ID number 26636, logical camera #3).

1.Call the camera up to the screen you are viewing (i.e. CAMERA-3-ENTER).

2.Press ON-999-ENTER to display the screen shown in FIGURE 2.

Figure 2: Fast Address

Any camera without a FastAddress will display the screen in FIGURE 2 when the ON-999-ENTER command is used. Make sure you are viewing the camera that you want to program.

If the camera’s FastAddress is the same as the keyboard camera number, ON-999-ENTER causes

the camera to enter the FastAddress mode, which is required to change or disable a FastAddress.

ON-998-ENTER causes all cameras, regardless of FastAddress status, to enter the addressing mode.

3.Press ON-26-ENTER to display the screen shown in FIGURE 3. At this point, any camera whose ID does not begin with 26 will exit the FastAddress mode.

Figure 3: Fast Address, continued

4.Press ON-636-ENTER to display the screen shown in FIGURE 4. At this point, Camera ID 26636 will be the only camera in the FastAddress mode.

Figure 4: Fast Address, continued

5.Press ON-1-ENTER and the address is set. The FastAddress is stored to nonvolatile memory and will not change if power is removed or factory defaults are restored (SET-899-ENTER).

To check/confirm the address, call up the camera and press ON-997-ENTER. This command causes all cameras to briefly display their addresses.

Incompatibility Statement:

The BasicDomes use the remote addressing feature, FastAddress, exclusively. There is no manual way to set the address using switches. Hence, these domes are not compatible with Bosch systems that meet the following criteria:

•Fixed Speed Keyboards.

•LTC 8500 / LTC 8600 / LTC 8800 CPUs having version 5.2 or older.

•Any LTC 8500 / LTC 8600 / LTC 8800 CPUs without two 8-position dip switches.

•Any LTC 8600 / LTC 8800 sold before 6/94 and LTC 8500 sold before 5/95.

Older LTC 8500 / LTC 8600 / LTC 8800 systems can be upgraded by replacing the CPU with the current version. Changes to other system accessories may also be necessary when upgrading to variable speed

(i.e., keyboards, receiver/drivers, port expanders, etc.).

Bosch Security Systems 10 December 2003