Setting the Preset Tour period | Bosch Appliances BasicDome Series

Indoor Pendant & In-ceiling Models User Manual On-Screen Programming	EN UM4

1.3Setting the Preset Tour period

To change the time duration between Presets during a Preset Tour, type ON-15-ENTER and use the joystick for adjustments (see FIGURE 4).

Figure 4: Preset Tour Period Adjustments

1.4Record/Playback Tours

Two independent macros (series of commands) can be recorded: A & B. These macros can be several hours in duration, although tours involving constant commands only last minutes. While recording, the on-screen display (see FIGURE 5) indicates remaining memory. To begin recording on A, move the camera to the desired starting point, then type ON-100-ENTER. The BasicDome now records all camera activities until the recording is ended by OFF-100-ENTER. Once A has been recorded, B is available via the ON/OFF-101-ENTER command. Playback can be continuous (ON-50-ENTER FOR A, ON-52-ENTER FOR B) or one shot (ON-51-ENTER FOR A, ON-53-ENTER FOR B).

Figure 5: Recording

1.5Changing AutoPan and AutoScan

Speeds

The AutoPan and AutoScan speeds (see FIGURE 6) can be adjusted via ON-14-ENTER. Use the joystick to adjust the speed. It is helpful for the Pan or Scan to be active when entering ADJUST mode to see the speed change.

Figure 6: AutoPan / AutoScan Speed Adjust

For additional information or the nearest Bosch location, visit our web site at

www.boschsecuritysystems.com.

Bosch Security Systems 10 December 2003