Axis Communications AXIS MFD-R Resetting to the Factory Default Settings, Further information

AXIS 209FD/FD-R/FD-R M12/MFD/MFD-R/MFD-R M12 Installation Guide Page 15

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory Default settings:

1.Disconnect the network cable from the camera.

2.Using the supplied allen/hex key, loosen the 4 screws holding the cover and remove it.

3.Press and hold the Control button and reconnect the network cable.

4.Keep the Control button pressed until the Status indicator displays amber (this may take up to 15 seconds).

5.Release the Control button. When the Status indicator displays green (which can take up to 1 minute) the process is complete and the camera has been reset.

6.Re-assign the IP address, using one of the methods described in this document.

It is also possible to reset parameters to the original factory default settings via the web interface. For more information, please see the online help or the user’s manual.

Further information

The user’s manual is available from the Axis Web site at www.axis.com or from the Axis Network Video Product CD supplied with this product.

Tip!

Visit www.axis.com/techsup to check if there is updated firmware available for your AXIS 209FD/FD-R/FD-R M12/MFD/MFD-R/MFD-R M12. To see the currently installed firmware version, see the Basic Configuration web page in the product’s Setup tools.

ENGLISH