Bosch Appliances NDN-932 installation manual Maintenance, Testing the network connection, Repairs

Page 42

42 en Maintenance

FLEXIDOME HD

 

 

9Maintenance

9.1Testing the network connection

The ping command can be used to check the connection between two IP addresses. This allows testing whether a device is active in the network.

1.Open the DOS command prompt.

2.Type ping followed by the IP address of the device.

If the device is found, the response appears as " Reply from ... ", followed by the number of bytes sent and the transmission time in milliseconds. Otherwise, the device cannot be accessed via the network. This might be because:

The device is not properly connected to the network. Check the cable connections in this case.

The device is not correctly integrated into the network. Check the IP address, subnet mask, and gateway address.

9.2Repairs

CAUTION!

Never open the casing of the unit. The unit does not contain any user serviceable parts. Ensure that all maintenance or repair work is performed only by qualified personnel (electrical engineering or network technology specialists). In case of doubt, contact your dealer's technical service center.

9.2.1Transfer and disposal

The camera should only be passed on together with this installation guide. The unit contains environmentally hazardous materials that must be disposed of according to law. Defective or superfluous devices and parts should be disposed of professionally or taken to your local collection point for hazardous materials.

AM18-Q0615 v1.0 2012.10

Installation Manual

Bosch Security Systems

Image 42
Contents Flexidome HD 1080p HDR RD Page Table of Contents Troubleshooting InstallationCamera configuration MaintenanceTechnical Data Safety Safety precautionsImportant safety instructions Connection in applications Type labelGrounding FCC & Ices compliance FCC & Ices InformationMicroSD cards UL certificationDisclaimer Bosch notices Copyrights Features IntroductionSystem Information Overview of functionsAudio Alarm I/OPower-over-Ethernet Tamper detection and motion detectionConfiguration RecordingBosch Video Client Operation with external systemsBosch Video Management System Bosch Recording StationPlanning UnpackingSystem requirements Installation PartsMounting the unit Surface mountingFlexidome HD Flush mount Figure?5.2?Flush mountingFlexidome HD Connections Wire colorSignal Make the connectionsPower connection Alarm InputNetwork and PoE connection Alarm output Audio in / Audio outMount the camera module Opening the camera module Controls Camera set-up Camera positioning 1 PanTilt Twist Using the install wizard Adjustment procedureClosing the unit Camera configuration Day/Night switchingUser modes Browser connection Protected networkTroubleshooting Function testResolving problems Malfunction Possible causes SolutionLivepage Functions Customer service For example 192.168.0.80/versionRepairs MaintenanceTesting the network connection Transfer and disposalTechnical Data SpecificationsIP, IBP, Ibbp 10.1.1 Dimensions Flexidome HD Page Bosch Security Systems