Mounting LENS/FOCUS Adjustment

The following installation should be a made by qualified service personnel or system installers.

Installation of Auto Iris Lens Connector

Install the lens connector (YFE4191J100) when using a video drive ALC lens.

(1)Cut the iris control cable at the edge of the lens connector to remove the existing lens connector and then remove the outer cable cover as shown in the figure below.

The pin assignment of the lens connector is as follows: Pin 1: Power source; +9 V DC, 50 mA max.

Pin 2: Not used	Rib
Pin 3: Video signal; 0.7 V[p-p]/40 kΩ	Pin 3
Pin 4: Shield, ground	Pin 1

(2)Solder the lens cable to the pins of the supplied connector.

Pin 4

Pin 2

Caution for Mounting the Lens

Follow the indication shown in the figure for the protrusion between a lens and the camera body. This camera wears mount for use with the CS-mount lens at the factory shipment.

Use the supplied C-mount adapter when using the C-mount lens.

The lens less than 450 g (0.99 lbs) can be mounted on the camera. If the lens is heavier, both the lens and camera should be

secured by the supporter.

C-mount: Less than 13 mm (1/2”)

CS-mount: Less than 8 mm (5/16”)

Mounting the Lens

Note: Before you mount the lens, loosen the screw on the side of the camera, and rotate the ring clockwise until it stops.

If the ring is not at the end, the inner glass or CCD image sensor may be damaged.

1.Mount the lens by turning it clock- wise on the lens mount of the cam- era.

Note: When mounting the C-mount lens on the camera, mount the C-mount adapter by turning it clockwise in advance.

2.Connect the lens cable to the auto iris lens connector on the side of the camera.

Lens Mount

C-mount Adapter

WV -CP470

Flange-back

Flange-backAdjusting Ring

Fixing Screw

Flange-back Adjustment

1.Loosen the flange-back fixing screw on the flange-back adjusting ring.

2.Turn the flange-back adjusting ring to obtain a focused point while watching the monitor screen.

3.Tighten the flange-back fixing screw on the flange-back adjusting ring.

Caution: Tightening the screw by force will cause damage to the screw or deviation of focus.

Note: The object may be out of focus when using a source of near-infrared light than using the visible light.

INSTALLATION OF CAMERA

•Mounting from the Top

Remove the mount adapter from the bottom of the camera by removing the two fixing screws. Attach the mount adapter to the top as shown in the figure, then mount the camera on the mounting bracket.

Make sure that the two original fixing screws are used when mounting the mount adapter as longer length screws may damage inner components, or shorter type screws may cause the camera drop.

Fixing Screws

Mount Adapter

WV -CP470