Axis Communications 211M user manual Terminal Connector, Connection diagram

AXIS 211M - I/O Terminal Connector

I/O Terminal Connector

The I/O terminal connector is used in applications such as motion detection, event triggering, time lapse recording and alarm notifications. It provides the interface to:

•1 transistor output - For connecting external devices such as relays and LEDs. Con- nected devices can be activated by AXIS VAPIX AP, output buttons on the Live View page or by an Event Type. The output will show as active (shown under Event Config- uration > Port Status) if the alarm device is activated.

•1 digital input - An alarm input for connecting devices that can toggle between an open and closed circuit, for example: PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes active (shown under Event Configuration > Port Status).

•Auxiliary power and GND

Pin 4	Pin 2
Pin 3	Pin 1

Terminal connector. Note that the pins are numbered 1-4, right to left.

Function	Pin number	Notes	Specifications
GND	1
5V DC Power	2	Can be used as an alternative power supply (7-20VDC) or to power	Max load = 100mA
		auxiliary equipment +5VDC (100mA).
Digital Input	3	Connect to GND to activate, or leave floating (or unconnected) to	Must not be exposed to voltages greater
		deactivate.	than
			20VDC
Transistor Output	4	Uses an open-collector NPN transistor with the emitter connected	Max load =100mA
		to the GND pin. If used with an external relay, a diode must be	Max voltage = 24VDC
		connected in parallel with the load, for protection against voltage	(to the transistor)
		transients.

Connection diagram

AXIS 211M

5V

max. 100mA

1o

e.g. pushbutton

2o

z

3 o

4

o

34