Section 2: Assembly and Installation
Pendant Mount
1.Attach the mounting plate to the bracket cap using the three screws as shown in Figure 3.1.
2.Locate a suitable position on the ceiling for a 34mm (+2 /
3.Cut a hole in the ceiling according to the template.
4.Drill four separate 6mm holes corresponding to the holes in the mounting template
| and insert the plastic anchors into these holes. | Mounting |
5. | Place the rubber seal between the pendant bracket and the ceiling to ensure a | Plate |
| ||
| waterproof seal between the ceiling and the bracket. (Figure 3.2) |
|
6. | Attach the pendant bracket to the ceiling using the screws provided. |
|
7. | Attach the bracket cap to the bottom of the pendant bracket by rotating the cap |
|
| counterclockwise to tighten it into place. |
|
8. | Insert the screw into the base of the pendant bracket at the top of the bracket cap to |
|
| secure the bracket cap into place. |
|
Figure 3.2
Bracket
Cap
Figure 3.1
Rubber
Seal
Pendant
Bracket
Bracket
Cap
15 |