D-Link DCS-6513 user manual Wall Mount Bracket

Page 18

Section 2: Assembly and Installation

Wall Mount

1.Attach the mounting plate to the bracket cap using the three screws as shown in Figure 4.1.

2.Locate a suitable position on the wall for a 34mm (+2 / 0 mm) hole to be cut. A template is included to aid in marking the mounting hole.

3.Cut a hole in the ceiling according to the template

4.Drill four separate 6mm holes corresponding to the holes in the mounting template and insert the plastic anchors into these holes.

5.Place the rubber seal between the wall mount bracket and the wall to ensure a waterproof seal between the wall and the bracket. (Figure 4.2)

6.Attach the wall mount bracket to the wall using the screws provided.

7.Attach the bracket cap to the bottom of the wall mount bracket by rotating the cap counterclockwise to tighten it into place.

8.Insert the screw into the base of the wall mount bracket at the top of the bracket cap to secure the bracket cap into place.

Bracket

Cap

Mounting

Figure 4.1

Plate

 

Wall Mount

Bracket

9.Connect the Ethernet cable and the power cable and thread them through the wall mount bracket.

Figure 4.2

Bracket Cap

D-Link DCS-6513 User Manual

18

Image 18
Contents Full HD WDR Day & Night Outdoor Dome Network Camera Trademarks PrefaceManual Revisions Revision Date DescriptionTable of Contents Package Contents Product OverviewIntroduction System RequirementsFeatures Hardware Overview FrontProtective Casing Cable Harness Internal Concealed Cable Installation Style 1 Concealed Cable InstallationMounting Assembly and Installation Exposed Cable Installation Style 2 Exposed Cable InstallationAssembly and Installation Assembly and Installation Pendant Mount PlateAssembly and Installation Assembly and Installation Wall Mount Wall Mount BracketDome Camera Weather Shield Installation Install 37mm Screws Weather Shield Remove Existing ScrewsConnection Using 12V DC Power Adapter Connection Using 24V AC Power Wiring Connection with a PoE Switch Adjusting the lens 3-axis Gimbal Adjust the Viewing Angle of the 3-axis MechanismSoftware Installation StepAssembly and Installation Assembly and Installation ViewCam Setup Wizard StepClick Finish to complete the installation Configuration Using the Configuration InterfaceLive Video Record a Video Clip Setup Setup WizardInternet Connection Setup Wizard Enter a name for your camera and click Next to continue Configuration Motion Detection Setup Wizard Configuration Network Setup Configuration Enable CoS Enable QoS Enable IPv6 Dynamic DNS Image Setup Configuration Audio and Video Configuration Lens Control Zoom ControlFocus Control Preset Configuration Motion Detection Time and Date Event Setup MediaServerConfiguration Add Server Add Media SNAPSHOTS20080104100341 Add Event Add Recording Size you specify SD Card Advanced Digital Input/OutputICR and IR Https Access List For exampleMaintenance Device ManagementSystem Firmware Upgrade Status Device InfoLogs Help DI/DO Specifications Technical Specifications CameraSystem Dimensions FCC Statement Safety StatementsCE Mark Warning FCC CautionFCC Radiation Exposure Statement Industry Canada NoticeRadiation Exposure Statement Contacting Technical Support Phone SupportWarranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantySubmitting a Claim USA Submitting a Claim Canada What Is Not Covered Disclaimer of Other WarrantiesWhat Is Not Covered FCC Caution Industry Canada Statement Registration