D-Link manual Hardware Installation, Attach the Antennas DCS-1130 only

Page 19

Section 3 - Installation

Hardware Installation

Attach the Antennas (DCS-1130 only)

Screw the wireless antennas onto the antenna connectors.

Connect the Camera to the Camera Base

1.Screw the two camera base pieces together.

2.Screw the camera base into the mounting point on either the back or the bottom of the camera and tighten the collar.

You can adjust the angle and pivot of the camera by loosening the wheel and retightening it after moving it to the desired position.

D-Link DCS-1100/1130 User Manual

14

Image 19

Contents Page Manual Overview Trademarks Manual RevisionsRevision Date Table of Contents Warranty Registration Table of ContentsProduct Overview Features Product Overview Package Contents Browser Requirements System RequirementsNetwork Requirements Computer with the followingFront Hardware OverviewBack Connects to the wireless antennasMydlink Portal Camera Status Live Video Camera Settings Camera Info Starting the Camera Installation Wizard InstallationAttach the Antennas DCS-1130 only Hardware InstallationConnect the Camera to the Camera Base Connecting to a router Connect the Power AdapterConnect the Ethernet Cable WPS Wireless Network Connection DCS-1130 only Using the Configuration Menu Web-based Configuration Utility Live Video Camera Setup Wizard SetupSetup Network Setup Configuration Ssid The Ssid of the wireless access point you wish to use Setup Wireless DCS-1130 onlySetup Dynamic DNS Setup Image Setup Setup Audio and Video Configuration Configuration Setup Motion Detection Setup Time and Date Setup Recording Continuous This will set the camera to record continuously Recording OptionsSetup Snapshot Configuration Configuration Maintenance Admin MaintenanceConfiguration Maintenance System Maintenance Firmware Upgrade Status Device Info StatusStatus Log Help What is Remote Access? How do I enable it? TroubleshootingWhat can I do if I forget my password? Identify Your Camera on the Network Installing the DCS-1100/1130 on a Router Without UPnPAssign an IP Address and Port for Your Camera Open the Http Port Router Setup Select TCP under Traffic Type Use Port Forwarding to Enable Remote Image ViewingViewing Your Camera Over the Internet Behind a Router Viewing Your Camera Over the InternetTechnical Specifications Weight Audio Codec Storage TemperaturePower Dimensions WxDxHFor customers within the United States Contacting Technical SupportLimited Warranty WarrantyNon-Applicability of Warranty Limited Software WarrantySubmitting a Claim USA Submitting a Claim Canada Disclaimer of Other Warranties What Is Not CoveredCopyright Statement Limitation of LiabilityGoverning Law TrademarksFCC Statement CE Mark WarningFCC Caution Important Note Industry Canada StatementRegistration