D-Link DCS-1130 manual Open the Http Port

Page 52

Appendix A - Installing the DCS-1100/1130 on a Router Without UPnP

3) Open the HTTP Port

The HTTP port option under Port Detail Settings is used when multiple cameras are being installed behind a single public IP address and will be accessed remotely OR for using a port other than the default port for image viewing. For each additional camera that is installed, you must assign the appropriate Web server port for each camera to enable remote viewing.

By default, port 80 (Web server port) is open. If these ports are available for use, you DO NOT have to open a second port and can proceed to the next section.

If port 80 is not available (for example, if you are already using port 80 to run a Web server or your ISP blocks access on port 80), you MUST open a second port and designate a new Web server port (800, 801, 802, etc.). Similarly, if port 554 is not available, you will need to open a different port for RTSP.

Note: Be sure to take note of these settings since these same settings will be used to configure your router.

Note: Some ISPs block traffic on commonly used ports like port 80 to disallow consumers from putting a server on their network. Be sure to check with your ISP so that you can open the appropriate ports accordingly. If your ISP does not pass traffic on port 80, you will need to change the Web server port the camera uses from 80 to something else, like 800. If you are behind a residential gateway, you will need to open a corresponding port on your gateway as well. Not all gateways are the same. Please refer to your gateway’s user’s manual for specific instructions on how to forward ports.

D-Link DCS-1100/1130 User Manual

47

Image 52
Contents Page Manual Overview Trademarks Manual RevisionsRevision Date Table of Contents Table of Contents Warranty RegistrationProduct Overview Features Product Overview Package Contents System Requirements Network RequirementsComputer with the following Browser RequirementsHardware Overview FrontConnects to the wireless antennas BackMydlink Portal Camera Status Live Video Camera Settings Camera Info Installation Starting the Camera Installation WizardAttach the Antennas DCS-1130 only Hardware InstallationConnect the Camera to the Camera Base Connecting to a router Connect the Power AdapterConnect the Ethernet Cable WPS Wireless Network Connection DCS-1130 only Using the Configuration Menu Web-based Configuration Utility Live Video Camera Setup Setup WizardSetup Network Setup Configuration Setup Wireless DCS-1130 only Ssid The Ssid of the wireless access point you wish to useSetup Dynamic DNS Setup Image Setup Setup Audio and Video Configuration Configuration Setup Motion Detection Setup Time and Date Setup Recording Recording Options Continuous This will set the camera to record continuouslySetup Snapshot Configuration Configuration Maintenance Maintenance AdminConfiguration Maintenance System Maintenance Firmware Upgrade Status Status Device InfoStatus Log Help Troubleshooting What is Remote Access? How do I enable it?What can I do if I forget my password? Installing the DCS-1100/1130 on a Router Without UPnP Identify Your Camera on the NetworkAssign an IP Address and Port for Your Camera Open the Http Port Router Setup Use Port Forwarding to Enable Remote Image Viewing Select TCP under Traffic TypeViewing Your Camera Over the Internet Viewing Your Camera Over the Internet Behind a RouterTechnical Specifications Audio Codec Storage Temperature PowerDimensions WxDxH WeightContacting Technical Support For customers within the United StatesWarranty Limited WarrantyNon-Applicability of Warranty Limited Software WarrantySubmitting a Claim USA Submitting a Claim Canada What Is Not Covered Disclaimer of Other WarrantiesLimitation of Liability Governing LawTrademarks Copyright StatementFCC Statement CE Mark WarningFCC Caution Industry Canada Statement Important NoteRegistration