D-Link manual WPS Wireless Network Connection DCS-1130 only

Page 21

Section 3 - Installation

WPS Wireless Network Connection (DCS-1130 only)

If your router supports WPS connection, you can connect your camera using the WPS button on the camera.

Press and hold the WPS button on the side of the camera for three seconds. The status LED on the front of the camera will turn blue.

Press the WPS button on your router within 60 seconds. The WPS button is usually on the front or side of your router. On some routers, you may need to log in to the web interface and then click on an onscreen button to activate the WPS feature. If you are not sure where the WPS button is on your router, please refer to your router’s User Manual.

The DCS-1130 will then automatically create a wireless connection to your router.

While connecting, your camera’s LED will flash and then your camera will reboot.

After rebooting, the status LED on the front of the camera will turn solid green.

D-Link DCS-1100/1130 User Manual

16

Image 21

Contents Page Manual Overview Manual Revisions TrademarksRevision Date Table of Contents Warranty Registration Table of ContentsProduct Overview Features Product Overview Package Contents Network Requirements System RequirementsComputer with the following Browser RequirementsFront Hardware OverviewBack Connects to the wireless antennasMydlink Portal Camera Status Live Video Camera Settings Camera Info Starting the Camera Installation Wizard InstallationHardware Installation Attach the Antennas DCS-1130 onlyConnect the Camera to the Camera Base Connect the Power Adapter Connecting to a routerConnect the Ethernet Cable WPS Wireless Network Connection DCS-1130 only Using the Configuration Menu Web-based Configuration Utility Live Video Camera Setup Wizard SetupSetup Network Setup Configuration Ssid The Ssid of the wireless access point you wish to use Setup Wireless DCS-1130 onlySetup Dynamic DNS Setup Image Setup Setup Audio and Video Configuration Configuration Setup Motion Detection Setup Time and Date Setup Recording Continuous This will set the camera to record continuously Recording OptionsSetup Snapshot Configuration Configuration Maintenance Admin MaintenanceConfiguration Maintenance System Maintenance Firmware Upgrade Status Device Info StatusStatus Log Help What is Remote Access? How do I enable it? TroubleshootingWhat can I do if I forget my password? Identify Your Camera on the Network Installing the DCS-1100/1130 on a Router Without UPnPAssign an IP Address and Port for Your Camera Open the Http Port Router Setup Select TCP under Traffic Type Use Port Forwarding to Enable Remote Image ViewingViewing Your Camera Over the Internet Behind a Router Viewing Your Camera Over the InternetTechnical Specifications Power Audio Codec Storage TemperatureDimensions WxDxH WeightFor customers within the United States Contacting Technical SupportLimited Warranty WarrantyLimited Software Warranty Non-Applicability of WarrantySubmitting a Claim USA Submitting a Claim Canada Disclaimer of Other Warranties What Is Not CoveredGoverning Law Limitation of LiabilityTrademarks Copyright StatementCE Mark Warning FCC StatementFCC Caution Important Note Industry Canada StatementRegistration