D-Link DCS-1130 manual Configuration

Page 33

Section 4 - Configuration

Enable Night Mode: Check this box to enable Night Mode. Night mode allows the camera to use a longer shutter speed when the camera is in a low-light environment. If the camera is in an area where there is sufficient lighting, Night Mode will not affect the video stream.

Shutter: This sets the longest shutter speed Night Mode will use when Night Mode is enabled and the camera is viewing a low-light scene.

Light Source: Here you can set the kind of lighting used in the area your camera is monitoring to improve the image quality of the video.

Enable Microphone: Checking this box will enable you to listen to audio picked up by the camera’s microphone. This will allow you to hear what is happening near your camera.

Volume: This sets the volume level of the incoming audio.

Note: Higher frame size, frame rate and bit rates will give you better video quality, but they will also require more network bandwidth. For best viewing results on a mobile phone, we suggest setting the frame rate to 5 fps and bit rate to 20 Kbps.

After making any changes, click the Save Settings button to save your changes, or click the Don’t Save Settings button to discard your changes.

D-Link DCS-1100/1130 User Manual

28

Image 33
Contents Page Manual Overview Manual Revisions TrademarksRevision Date Table of Contents Warranty Registration Table of ContentsProduct Overview Features Product Overview Package Contents Network Requirements System RequirementsComputer with the following Browser RequirementsFront Hardware OverviewBack Connects to the wireless antennasMydlink Portal Camera Status Live Video Camera Settings Camera Info Starting the Camera Installation Wizard InstallationHardware Installation Attach the Antennas DCS-1130 onlyConnect the Camera to the Camera Base Connect the Power Adapter Connecting to a routerConnect the Ethernet Cable WPS Wireless Network Connection DCS-1130 only Using the Configuration Menu Web-based Configuration Utility Live Video Camera Setup Wizard SetupSetup Network Setup Configuration Ssid The Ssid of the wireless access point you wish to use Setup Wireless DCS-1130 onlySetup Dynamic DNS Setup Image Setup Setup Audio and Video Configuration Configuration Setup Motion Detection Setup Time and Date Setup Recording Continuous This will set the camera to record continuously Recording OptionsSetup Snapshot Configuration Configuration Maintenance Admin MaintenanceConfiguration Maintenance System Maintenance Firmware Upgrade Status Device Info StatusStatus Log Help What is Remote Access? How do I enable it? TroubleshootingWhat can I do if I forget my password? Identify Your Camera on the Network Installing the DCS-1100/1130 on a Router Without UPnPAssign an IP Address and Port for Your Camera Open the Http Port Router Setup Select TCP under Traffic Type Use Port Forwarding to Enable Remote Image ViewingViewing Your Camera Over the Internet Behind a Router Viewing Your Camera Over the InternetTechnical Specifications Power Audio Codec Storage TemperatureDimensions WxDxH WeightFor customers within the United States Contacting Technical SupportLimited Warranty WarrantyLimited Software Warranty Non-Applicability of WarrantySubmitting a Claim USA Submitting a Claim Canada Disclaimer of Other Warranties What Is Not CoveredGoverning Law Limitation of LiabilityTrademarks Copyright StatementCE Mark Warning FCC StatementFCC Caution Important Note Industry Canada StatementRegistration