Samsung SCC-C6403 instruction manual White BAL, Dis

Page 20

WHITE BAL

Lights are generally denoted as color temperatures and expressed in Kelvin (K) units.

The general light color temperatures are shown below.

10000K

Blue sky

9000K

Rainy

 

8000K

 

7000K

Cloudy

 

6000K

Partly Cloudy

5000K

Sunny

 

4000K

Fluorescent lamp

3000K

 

You can select one of four modes for white balance adjustment as follows:

-ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes, the color temperature is monitored continuously and thereby white balance is set automatically. The following are the approximate supported color temperature ranges in these modes.

ATW1 : 2500K ~ 9300K(1)

ATW2 : 2000K ~ 10000K(Mode recommended for sodium lighting)(2)

1. If the color temperature is out of this range in ATW1 mode, proper white balance may not be obtained. In that case, select ATW2 mode.

2. In ATW2 mode, if one color is dominated in the shooted area, the color can be displayed differently.

Therefore, select the mode which is appropriate for the environment.

-AWC(Auto-Tracing White Balance Control): In this mode, accurate white balance is obtained by pressing [ENTER] while having a white paper in front of the camera. White Balance data will be maintained after set it once. AWC mode is best in locations where the color temperature of light source is constant.

-MANU : If WHITE BAL menu is set to MANU mode, the user can set the white Balance considering the current illumination. Select MANU item and press [ENTER], the sub screen where you can select Manual White Balance will be shown. Use the left/right keys to select 3200K, 5600K or OFF(USER) mode in the PRESET menu.

-3200K : Set color temperature to 3200K

-5600K : Set color temperature to 5600K

-USER : Choose out a proper value from the RED and BLUE graph for color and temperature setup.

E

Halogen lamp

2000K

Tungsten lamp

Candlelight

1000K

(VIDEO SET)

 

IRIS

ALC...

SHUTTER

OFF

AGC

LOW

WHITE BAL

 

MANU...

DIS

ON

FOCUS MODE

ONEAF

SPECIAL

...

EXIT

QUIT

Press [Enter]

(AWB/MANU)

PRESET3200K

RET

DIS

The DIS(Digital Image Stabilization) function compensates the camera screen shaking incurred from vibration.

It is recommended to deactivate the DIS function in the no vibration environment.

From VIDEO SET, if you set SHUTTER to between AUTO X2... and AUTO X128... DIS will be displayed as “---“ (it can operate only in Off mode).

You can’t adjust the settings manually.

3-14

3-15

Image 20
Contents SCC-C6403 Important Safety Instructions FCC Statement Before Usage Chapter Locations of Control Adapter Connection Initial Setting Camera Address SetupBefore Installing Preparing the Cables Indoor Housing SHG-120 Outdoor Housing SHG-220Ceiling Mount Bracket SBR-100DCM Wall Mount Adaptor SADT-100WMCeiling Mount Adaptor SADT-100CM Pole Mount Adaptor SADT-100PMSetup Menu Overv iew Structure of the Setup Menu Camera ID Camera SET MenuSync COLOR/BW Motion DETDigital Zoom Zoom SpeedDisplay Zoom Display P/TVideo SET Menu ExitIris ALCShutter AGCMotion FlickerlessWhite BAL DISPreset Focus ModeSpecial LevelZone SET Zone Enable Zone AreaLocation Zone ID SETAuto SET Auto PANSpeed Dwell TimeAuto Play Auto ReturnScan Play NumberAlarm SET Other SETSystem Info Short Keys Function KeyProduct specifications