TURBO P/T
This function doubles up the speed of PAN/TILT movement by manual operation of PAN/TILT. The speed may go up to 180°/sec(PAN).
AUTO CAL
This function turns on or off Auto Calibration.
(OTHER SET)
PROPORTIONAL P/T ON
TURBO P/T | OFF |
AUTO CAL. | OFF |
AUTO FLIP | ON |
CAM RESET | ... |
LANGUAGE | ENGLISH |
PASSWORD | ON... |
EXIT | QUIT |
➜
Press [Enter]
(PASSWORD)
0 | 1 | 2 | 3 |
| 4 | ||
5 | 6 | 7 | 8 |
| 9 | ||
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| ✽ | ✽ ✽ | ✽ |
| |
|
|
|
|
|
| ||
|
|
|
|
|
| ||
|
|
| ✽ ✽ ✽ | ✽ |
| ||
|
|
|
|
|
|
|
|
RET
the time designated by the user, A.C will appear on the screen while initializing LENS and PAN/TILT.
AUTO FLIP
When TILT is set to a 90° limit using the joystick, PAN automatically rotates by 180°
enabling you to see up to the Tilt area on the opposite side .
You can obtain an extended effect with the 180° operational range of the TILT feature.
CAM RESET
Press UP/DOWN/LEFT/RIGHT key to locate the cursor on a number and press [ENTER] for password setup. After you finish inputting the 4 digits password and the 2nd row of the 4 digits PASSWORD input screen, input the selected password again for reassurance.
If correct, the cursor will move to RET.
Press [ENTER] at RET, and the selected password will be saved, returning to the OTHER SET screen.
Default password is 0123.
8. SYSTEM INFO
This menu allows you to check S/W version, communication protocol, baud rate, and address of
E
CAM RESET clears all the settings made so far and restores the factory default settings.
"CAMERA RESET?" message appears when you select CAM RESET. Select "CANCEL" to return to the menu setup display or select OK to restore the factory default settings.
❈Be careful when performing a CAM RESET operation, as it deletes all setup values.
LANGUAGE
This function selects a language for MENU setup. Press LEFT/RIGHT key to choose English, French, Spanish or Jepanese and the selected
language will be applied to the full screen.
PASSWORD
This function selects or cancels the MENU setup password. Press [ENTER] at the state of PASSWORD ON..., and the following screen will appear for password setup.
** MAIN MENU **
CAMERA SET...
VIDEO SET...
PRESET...
ZONE SET...
AUTO SET...
ALARM SET...
OTHER SET...
SYSTEM INFO...
➜
Press [Enter]
( SYSTEM INFO)
ALARM VER. | V1.000 | |
MOTOR VER. | V1.000 | |
CAMERA VER. | V1.000 | |
EEPROM VER. V1.000 | ||
PROTOCOL | SAMSUNG | |
COMM. TYPE | ||
BAUD RATE | 9600 | |
ADDRESS | 0 | |
SERIAL NO. | 000000000000000 | |
RET |
|
|