Cisco Systems 5505 manual Connecting to Network Interfaces

Page 4

Chapter 4 Installing the ASA 5505

Connecting to Network Interfaces

b.Use one of the yellow Ethernet cables to connect the device to a cable/DSL/ISDN modem.

Note By default, switch port 0 is the outside port.

Step 3 Connect your network devices with an Ethernet cable to one of the remaining seven switched ports (numbered 1 through 7).

If you are connecting any Power over Ethernet (PoE) devices, connect them to one of the switch ports that support PoE (ports numbered 6 and 7).

Connecting to Network Interfaces

To connect to a network interface, perform the following steps:

Step 1 Locate an RJ-45 to RJ-45 Ethernet cable.

Step 2 Connect one end of the Ethernet cable to an Ethernet port (ports 0 through 7) as shown in Figure 4-2. (Typically Ethernet port 0 is used to connect to an Internet router.)

 

ASA 5505 Getting Started Guide

4-4

78-18003-02

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Installing the ASA Verifying the Package ContentsContents of ASA 5505 Package Installing the Chassis PoE Ports and DevicesConnecting to Network Interfaces Powering on the ASA Connecting to an Ethernet InterfaceSetting Up a PC for System Administration Configuring the Adaptive Security ApplianceOptional Procedures Connecting to the ConsoleInstalling a Cable Lock Connecting to the ConsolePorts and LEDs Front Panel ComponentsPort / LED Color State Description VPN Rear Panel Components Port or LED PurposeContinue with , Configuring the Adaptive Security Appliance What to Do Next
Related manuals
Manual 2 pages 55.46 Kb
Top Page Image Contents