NordicTrack NTL15909.3 warranty Make sure that the power cord is unplugged

1. Make sure that the power cord is unplugged.	1							11
With the help of a second person, tip the incline
trainer onto its left side. Have the second per-								10
son hold the incline trainer to prevent it from									2
falling.
Attach four Base Feet (10) and four Base Foot
Spacers (11) to the Base (80) with four #8 x 1"
Tek Screws (2) in the locations shown. Be care-		11
ful not to overtighten the Tek Screws.			102
				80		11	10	2
			10 2
	11
2. Identify the Right Upright (79), which is marked	2
with a “Right” sticker. Hold the Right Upright							79
near the incline trainer.
See the lower inset drawing. Tie the wire tie in
the Right Upright (79) around the end of the				Wire
Upright Wire (78). See the upper inset draw-
ing. Then, pull the other end of the wire tie until				Tie		78
the Upright Wire is routed out of the side hole	78		79
near the top of the Right Upright.
Orient the Right Upright (79) as shown. Attach
the Right Upright to the Base (80) with two 3/8"				80
x 3 1/2" Patch Bolts (5) and two 3/8" Star
Washers (8). Start both Patch Bolts, and then		Wire
tighten each of them. Be careful not to pinch
the Upright Wire (78).		Tie
With the help of a second person, tip the incline					8
trainer onto its right side. Have the second per-						5
son hold the incline trainer to prevent it from
tipping.
Attach the Left Upright (not shown) as de-
scribed above. Note: There are no wires on the
left side.								79
						78
								Wire
								Tie

8