NordicTrack NTL15909.3 warranty Change the incline of the incline trainer as desired

Contacts

4.Change the incline of the incline trainer as desired.

To change the incline of the incline trainer, press the Incline increase and decrease buttons or one of the incline buttons numbered -3 to 40. Each time you press one of the buttons, the incline will gradu- ally change until it reaches the selected incline set- ting.

Note: As the incline changes, the maximum speed of the incline trainer will change. When the incline is from -3% to -2.5%, the maximum speed will be 8 mph; when the incline is from - 2% to -1.5%, the maximum speed will be 8.5 mph; when the incline is from -1% to -0.5%, the maximum speed will be 9 mph; when the in- cline is from 0% to 15%, the maximum speed will be 10 mph; when the incline is from 15.5% to 25%, the maximum speed will be 8 mph; and when the incline is from 25.5% to 40%, the max- imum speed will be 6 mph.

5.Monitor your progress with the display.

The console offers several display modes. The dis- play mode that you select will determine which workout information is shown. To select the de- sired display mode, repeatedly press the Display button or the increase and decrease buttons next to the Enter button.

As you walk or run on the incline trainer, the center display can show the following workout information:

•The incline level of the incline trainer

•The speed of the walking belt

•The elapsed time

•The distance that you have walked or run

•The approximate number of calories you have burned

•Your pace in minutes per mile or minutes per kilometer

•Your heart rate (see step 6 on this page)

Regardless of which display mode you select, the speed and incline settings will appear in the display for a few seconds each time you change the setting.

If desired, adjust the volume level by pressing the Volume (VOL) increase and decrease buttons on the console.

To reset the console, press the Stop button, re- move the key, and then reinsert the key.

6. Measure your heart rate if desired.

Before using the handgrip pulse sensor, remove the sheets of plas- tic from the metal contacts if necessary. In addition, make sure that your hands are clean.

To measure your heart rate, stand on the walking platform and hold the metal contacts on the handrail for approximately ten seconds—avoid moving your hands. When your pulse is detected, your heart rate will be shown. For the most accu- rate heart rate reading, continue to hold the contacts for about 15 seconds.

7.Turn on the fan if desired.

The fan features low and high speed settings. Press the Coolaire Fan increase and decrease but- tons repeatedly to select a fan speed or to turn off the fan. Note: If the fan is on when the walking belt is stopped, the fan will turn off automatically after a few minutes.

8.When you are finished exercising, remove the key from the console.

Step onto the walking platform and press the Stop button. Next, remove the key from the console and put it in a secure place.

When you are finished using the incline trainer, press the power switch into the off position and un- plug the power cord. IMPORTANT: If you do not do this, the incline trainerʼs electrical compo- nents may wear prematurely.

17