Samsung SID-500 user manual Connection, Connecting to Power

Page 9

Connection

Connecting to Monitor

Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.

CCTV Camera

Monitor

As the connecting method varies with the instruments, refer to the manual supplied with the instrument.

If necessary, you can connect the monitor to the REMOTE jack on the back of your camera.

Only connect the cable when the power is turned off.

Set the 75/ Hi-Z selection switch as shown below if you have an intermediate device.

Intermediate

End monitor

CCTV Camera

COLOR CCD CAMERA 16 User’s Manual

Connecting to Power

Connect the adaptor to the power input connector as shown in the figure below. The recommended adaptor specification for SID-500N/SID-500P is AC 24V / 500mA or DC 12V / 500mA.

When the resistance value of copper wire is at [20°C(68°F)]

Copper wire size (AWG)

#24(0.22mm2)

#22(0.33mm2)

#20(0.52mm2)

#18(0.83mm2)

Resistance (/ m)

0.078

0.050

0.030

0.018

Voltage Drop (V/m)

0.028

0.018

0.011

0.006

 

 

 

 

 

•As shown in the table above, voltage decreases as the wire gets longer. Therefore use of an excessively long adaptor output line for connection to the camera may affect the performance of the camera.

*Standard voltage for camera operation : DC 12V ± 10%

*There may be some deviation in voltage drop depending on the type of wire and the manufacturer.

Notes

Be sure to connect power only after all the installation is complete.

Note that AC or DC adaptor is not supplied with camera.

Use the UL listed, class 2 power transformer of AC 24V adaptor.

Ground should be connected to the GND terminal.

COLOR CCD CAMERA 17 User’s Manual

Image 9
Contents 10X Zoom SID-500 Series 10x Optical Zoom FeaturesContents Never keep the camera face to strong light directly PrecautionsOverview Installation InstallationSelect either 85X85 or When installing on a adapter plateConnection Connecting to PowerConnection Menu ConfigurationOperating Your Camera RS-485 communication controlSet CAM Title to on using the Left or Right button Menu SetupCAM Title Use the six buttons on back of the cameraCorrecting Mistakes When completed, move the cursor to END and press SET buttonWhite Balance Control Set White BAL using the Left or Right buttonBacklight Three white balance control modes are as followsFocus Motion DetectionOn Any motion in the selected areas is observed Press the SET buttonONE Push Focus is automatically adjusted just once Can be manually adjusted, independent of moving zoomManual Select Manual and press the SET button END To revert to the main setup menu ExposurePress the SET button to confirm Shutter Control image brightness by adjusting shutter speed FLK Ntsc 1/100, PAL 1/120 Flicker-free modeAuto The iris is automatically activated upon illumination Disabled DisabledOFF Disabled AGC Auto Gain Control For brighter imagesSpecial Preset Save Save configured presetEND Revert to the Special Setup menu Preset Clear Clear configured presetColor Color mode BW mode DAY/NIGHT Select from COLOR, BW or Auto modesTo reset your camera to factory default condition ResetTo finish setup menu ExitSpecifications TroubleshootingCommunication DimensionDeclaration of Conformity