Installation

Pan Base Holding Screws (Color : Silver)

fix panned position

Zoom Handle

adjust zoom between WIDE and TELE

Focus Handle

after adjusting zoom, adjust focus

SETUP button

Used for the menu display. Confirm the status of the selected function.

Left button Right button

Notes

•The installation should be done by qualified service personnel or sysytem installers.

•If the ceiling material is not strong enough to hold the installation screws, the camera may fall off. Reinforce the ceiling as needed.

1)Remove the dome cover and shield case from the main body by loosening the three dome cover screws.

Used when changing item values, by moving the cursor to the left or right on the menu screen

Down button

Used when changing item values, by moving the cursor to the up or down on the menu screen

Service connector for on-site camera set-up A terminal can be connected to an LCD monitor, allowing the operator to easily

*To install the dome cover on the camera body, turn the latches in locking direction as shown in the figure 1.

Mounting Bracket

Main Body (Camera)

adjust the camera angle within the monitoring range during its installation.

Service/ Monitor Cable

External Viewer (not supplied)

COLOR DOME CAMERA 12 User’s Manual

Latch

Locking direction

2) And then remove the main body from mounting bracket by the four main body screws.

COLOR DOME CAMERA 13 User’s Manual