When installing on a adapter plate

Installation

Adjust the panning and tilting, rotating while watching the monitor

An arrow for installing directions

adapter plate

M4 tapping screw (provided)

Camera body

1)Place the bracket provided on the installation surface and fix it with the M4 tapping screws (provided).(Select either 85X85 or 83.5X46)

2)When placing the camera body on the plate, insert the plate pin into the mounting hole on the body as shown in figure-1 and fix it by turning clockwise.

3)When placing the camera body on the plate, make sure the power and the BNC cables pass through their respective designated holes.(When placing the cable through its side, thread it through the hole at the bottom.)

4)After installation and adjustment of the camera are complete, secure the dome cover by turning it clockwise.

73˚

145˚195˚

170˚

Tilt Base

Rotate Base

-170˚

Pan Base

1)You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.

•Pan Base moves by 170˚ to each side direction and 340˚ on the whole.

•Tilt Base covers total 146˚ angle(73˚ to each side).

•Angle range of Rotate Base is the same as that of Pan Base. But One side range is 195˚ and another is 145˚.

2)Methods of adjustment

Unlocking	Locking	Plate pin
Unlocking	direction
direction

Dome cover

Locking

Unlocking

direction

[Figure-1]

Notes

•Please locate an arrow on bracket for installing direction that you wish to observe Area and then fix it with the M4 tapping screws.

COLOR DOME CAMERA 14 User’s Manual

•The case of wall installation

After mounting the camera on a wall, adjusting the panning angle so that the camera can face the direction to monitor when tilting.

And then adjust the tilting angle by rotating the tilt base.

Loosen the rotate base hold screw and adjust rotate base for the best monitoring. Tighten the rotate base hold screw.

•The case of ceiling installation

After mounting the camera on a ceiling, adjusting the panning angle for better monitoring area by rotating the pan base.

And then adjust the tilting angle by rotating the tilt base.

Notes

•When installing SID-452 be careful in setting lens focus and Tilt angle. If you set the lens focus max WIDE(f=3.0mm) and Tilt angle over 68˚, some portion of image will be screened by Dome cover.

COLOR DOME CAMERA 15 User’s Manual