Samsung SID-452 instruction manual Adjusting varifocal lens zoom and focus, Figure a

Page 9

Notes

•When adjusting the rotating angle, loosen rotate base holding screw as following Figure A. And then tighten it again.

•When adjusting the tilting angle, just grip the tilt base and adjust tilting angle.

•When adjusting the panning angle, loosen pan base holding screws as the following Figure B. And then tighten them again.

<Figure A>

•In case of adjusting the tilting, do not take the lens for preventing physical shocks. Please take the Tilt Base.

COLOR DOME CAMERA

16 User’s Manual

1)Unlock the zoom (or the focus) handle to release it

2)Adjust the zoom (or the focus) handle by moving it to WIDE (NEAR) or TELE (FAR) position.

3)After adjustment, tighten the zoom (or the focus) handle, taking care that the adjusted position does not change.

Focus handle

Zoom handle

COLOR DOME CAMERA 17 User’s Manual

Image 9

Contents SID-452 Correct Disposal of This Product Contents Built-in Auto Iris Vari-Focal Lens FeaturesPrecautions Pan Base CompositionRotate Base Holding Screw Rotate BaseInstallation InstallationWhen installing on a adapter plate Figure a Adjusting varifocal lens zoom and focusConnecting to a Monitor ConnectionConnect the VIDEO-OUT jack to the VIDEO-IN jack of monitor Settings Menu Setup menuPlease press the Setup button Camera OperationShutter condition and speed control LENSAdjusting to the brightness levelWhite Balance control Backlight Backlight CompensationPlease select one of the 3 modes below AGC Auto Gain Control Ssnr Samsung Super Noise reductionOFF There is no reduction in noise level SENS-UP Low illuminance Auto Low light level auto modeThen press the Setup button Please press the Setup buttonOn The color mode is selected electronically CornerMotion Detection OFF Cancels the Privacy modeSaves all the setting menus and then exits TroubleshootingNothing appears on ScreenSpecifications Dimension